Thanks for the video, it’s about time the UCI made these rule changes. I didn’t realize the 10cm height measurement was done with the pads off the bike. At four different GFWC champs and Canadian Provincials / Nationals they always measured with the pads on but it’s good to know we have 5mm of pad height allowance as well.
@AeroCoach
2 жыл бұрын
The measurement is to be taken with the pads off, but this is a relatively recent change so some commissaires have been making mistakes
@sethjones1477
Жыл бұрын
@@AeroCoach hi - what clause of the 01/01/23 regs is this 10cm from pad support (not top of pad) in - I can't find it thanks
@orionichild8477
Жыл бұрын
@@AeroCoachis there a document saying that? I looked and only this video says without the pads? I've seen multiple times the new rule in effect and they are measuring with the pad on
@AeroCoach
Жыл бұрын
@@orionichild8477 the UCI commissaires can choose to measure without the pad if they wish, which means you should always take your measurements with the pads off just in case
@adrianjones3396
Жыл бұрын
@aerocoach are you still allowed 5mm for pads? I have 94mm from top of pads and 104mm from top of pad support
@kkostasgr
Ай бұрын
Thanks for the video!
@user-cx2bk6pm2f
3 ай бұрын
Very well done.
@niekversteege
2 жыл бұрын
Thanks for the simple clarifications! One thing is not entirely clear to me though: when you have less than 50mm between saddle tip and bracket line, what does that mean for your reach? 75cm for each category?
@AeroCoach
2 жыл бұрын
Yes, that is correct
@niekversteege
2 жыл бұрын
@@AeroCoach Wow ok. Then it's worth it by a long shot. Even though for me it's not optimal.
@muhammadaliaslam3706
Жыл бұрын
In 2022 UCI itt event our saddle setback was minus 50 ie the saddle tip was 50mm past the bottom bracket line. Is it’s still allowed or the rules have changed? In 2022 it passed the bike check and this was measured. Thank you
@torontocycling
Жыл бұрын
Great video. So how can an AeroCoach Angles carbon aerobar extensions of 35° which raises 14.5 cm be UCI legal for riders of Cat 2 (180 to 190 cm)? You mentioned in the video that the max allowance is 12 cm.
@axteraa
2 жыл бұрын
In the case of mechanical shifting, when measuring the highest point of the extensions, is that taken with the shifter fully extended out away (as is done for the distance from the BB) or whatever position puts it highest (but slightly closer due to pointing up)?
@AeroCoach
2 жыл бұрын
For height it’ll be set in the highest position
@beltonhogue
Жыл бұрын
@@AeroCoach can you clarify a little more please.....so does this mean that for height measurement, that the mechanical shifter has to be clicked all the way back so that it is vertical, and then measure from the top point of the shifter......or is it to be measured horizontal, like the bottom bracket measurement, however, it is measured at the top of the shifter body,(not clicker)so that it's body is as tall as it can be, but the lever is still In the horizontal position, and it is measured at the top of the body?
@technowaltz5844
Жыл бұрын
May i know where is the di2 junction box has been fitted because i have exactly same bike and bars but with extrnal cabeling😢 may i know where to fit di2 junction box so the wiring can be internal?
@johnnyboy4711
Жыл бұрын
Hi Xavier,I have 3t aura basebar, looking to maximize the tilt as per UCI 2023 regs,do you have a solution for me? Thanks
@jazzjazz417
2 жыл бұрын
are the 80, 83 and 85 cm from the spindle line or the tip of the saddle?
@AeroCoach
2 жыл бұрын
Spindle line 🙂
@tomstephenson5452
2 жыл бұрын
Question: is there a rule on stack height (base bar to pad length)
@AeroCoach
2 жыл бұрын
Stack height - no, there are no regulations on stack height
@johnnyboy4711
Жыл бұрын
arm extension angle increased from 15 deg to 30 deg?
@AeroCoach
Жыл бұрын
Yes that has been changed now :)
@johnnyboy4711
Жыл бұрын
@@AeroCoach it's just a query,so I can go up to +30 degrees?
@AeroCoach
Жыл бұрын
@@johnnyboy4711 for the arm rest angle, yes you can :)
@rhysclarke5720
2 жыл бұрын
Is the 15 degree rule for the elbow pad and the forearm support or just the elbow support? As in for the aerocoach bars as in the video? Thanks
@calebgonsalves2970
Жыл бұрын
Just the armpad
@syeadon
2 жыл бұрын
Do the 25 degree extensions now fit within the UCI regulations for riders over 190cm?
@TheCraddingGuy
4 ай бұрын
According to the UCI, yes. "To accommodate the above regulations changes the maximum inclination angle of the forearm support of the handlebar extensions has been increased from 15 to 30°."
@heiko6376
2 жыл бұрын
Will you modify your extensions or at least the endgrippers - make them longer for Cat 2/3 riders?
@AeroCoach
2 жыл бұрын
You can purchase Ascalon extra reach plates on the website if you need more reach :)
@heiko6376
2 жыл бұрын
@@AeroCoach I don’t need more reach- I need more support length for the forearm (and I would like to keep the armpads close to the thicker part of the extensions).
@AeroCoach
2 жыл бұрын
@@heiko6376 we can custom make longer grippers for a new Ascalon purchase, that's no problem (it's not possible to modify existing Ascalons)
@gabrielkuchen4048
2 жыл бұрын
is there still the 15° regulation for the armpads?
@AeroCoach
2 жыл бұрын
Yes 🙂
@johnhickson527
2 жыл бұрын
Please share the UCi new rules. I can't find them on their website. Thanks
@AeroCoach
2 жыл бұрын
The new regulations and adjustments can be found here: assets.ctfassets.net/761l7gh5x5an/45KkrQwgmgYZknAIQtjZyg/328e1744671d9549a3ecd4afd840455b/1-GEN-20230101-E_amendments_on_01.01.2023.pdf
Пікірлер: 39