Need a wet grinder that heat takes some of the hardness out of the knives
@otel680
5 жыл бұрын
Thanks for the video, I just bought a Mott T38 and this is very helpful. A question for you, when I bought it the seller gave me the steel bracket that goes under or in back, is this good to have on it? I will mostly be cutting trails in the woods. Also can you lead me in a good direction for parts for these? Thanks again.
@frankmoreau8847
4 жыл бұрын
Flail Master flailmaster.com if the are still in business, has the most comprehensive catalog of flail parts and knives of anywhere on the web. I also found replacement knives at Quality Farm supply.
@otel680
4 жыл бұрын
@@frankmoreau8847 Awsome thanks again.
@halmain7406
7 жыл бұрын
Good video
@expatconn7242
2 жыл бұрын
Where can I find a Mott for 9920?
@robertorocchi9560
3 жыл бұрын
io x molare i denti sia della trincia che della lama della motofalce non uso il disco da mola ma uso il disco a lamelle di cartavetro che porta via meno...
@patrickwelch620
5 жыл бұрын
You should be using the d rings
@frankmoreau8847
4 жыл бұрын
Looked into that for my mower, by the time I purchased all the parts it would have cost me about $600 to convert. A full set of knives similar to those in the video cost me a little over $100. I'd stick with the original equipment.
Пікірлер: 11