This is like the only video on this subject. I have to test with 6-speed truck I’ve never driven before and I’m trying to get as much info as I can.
@midwesttruckdrivingschool
2 ай бұрын
Good luck with your test!
@mive5351
9 күн бұрын
Can u float gears in this transmission
@sikolasnikolas
Ай бұрын
I’m testing in a 6 speed. I usually like to start in 2nd gear. The problem I’ve been having is, my truck stalls out from time to time when taking off from a complete stop. Any advice to fix this problem would be greatly appreciated. Thank you 🙏🏽
@user-rk3od9do4s
11 күн бұрын
Had the same problem but learning how to control the clutch release and gas while taking off is a main key you prob let go of clutch to early what I do is raise my rmps and when it’s above 1 I half way let go off clutch you would feel the truck move then speed more up to 1.5 and let go of clutch completely it maybe :) it’s diff but that’s how I learned somehow starting off in 2nd gear because 3rd is too high to start off in a stop position
@ethanmaag1053
2 ай бұрын
With these, are you able to push the clutch down all the way to shift each gear
@midwesttruckdrivingschool
2 ай бұрын
With synchronized transmissions yes you push the clutch all the way to the floor when shifting gears up or down. With non-synchronized manual transmissions you "bump" the clutch a few inches as to not activate the clutch brake.
@johnfogerty6965
2 ай бұрын
I have trouble knowing when to slow down and stop when light is red or when light changes from red to green. Do you have any advice in those situations?
@eyvi.1750
2 ай бұрын
slow down to 15 mph and shift back to 1st
@midwesttruckdrivingschool
2 ай бұрын
When approaching a "stale green light", a light that has been green for a long time it is best to slow down and be prepared to stop. If at that point the light stays green then continue on through it, however if it changes you will be going slow enough to bring the truck to stop safely without having to slam on the brakes.
@chadchar3711
2 ай бұрын
when slowing down to down shift, should i apply brakes while slowing down or let off when down shifting?
@midwesttruckdrivingschool
Ай бұрын
It is typically advised to apply the brakes before you start slowing down as then you could focus on downshifting and that whole process. Thanks!
Пікірлер: 16