A tip from personal experience when soldering thin wires like in this video is to not twist the individual strands. Yes it makes it neater, but it also strains the bundle so much that solder may not be able to penetrate thoroughly and thus leave a weak connection between them.
@1peanut
6 ай бұрын
I could see your point. I recommend using flux which makes it flow into the wire nice.
@pnwRC.
3 жыл бұрын
Fantastic video! I had to share this in the Facebook PNWSTE (Pacific Northwest Scale Trucks & Equipment) that I help administrate. There are so many newbies that struggle with this topic. HOPEFULLY this video can answer any & all of their questions they have!
@jaysoncrichton-stuart9727
11 ай бұрын
I don't even need to solder anything but I loved this video. That and I wanted to be the dean of connector university.
@HobbiesDirect
11 ай бұрын
Ha! You even watched until the end :-D
@johneppstv
2 жыл бұрын
This is the best video how to something. Thanks!
@bert1913
4 ай бұрын
I heat the wire and connector with a little solder on the tip when tinning, then add the solder. Then I heat the opposite side of the connector and add wire to melted solder
@RRED2
3 жыл бұрын
Very informative and useful? Could you give me some idea on which soldering iron and watts would be best to use, Thanks (UK)
@codyrogers521
3 жыл бұрын
Much needed video
@bellowworld227
3 жыл бұрын
Really helpful. Nice vid👍
@HobbiesDirect
3 жыл бұрын
Thanks, good to know you found it helpful :)
@Ahmed91
6 ай бұрын
Thank you, dear, but can I use a 60-watt soldering iron?
@HobbiesDirect
6 ай бұрын
You can use whatever you like, but lower power irons will not be as fast/easy as higher power models 🙂
@noname.6011
4 ай бұрын
thanks bro
@HobbiesDirect
4 ай бұрын
Any time! :-)
@kadenw968
Жыл бұрын
great video
@HobbiesDirect
Жыл бұрын
Thanks!
@jasonanderson7020
2 жыл бұрын
i see that deans has these new plastic sheaths available do they just slide over once soldering is finished?
@Flatout56-o8k
3 жыл бұрын
I’m sorry but that heatshrink kills me😂 pls use something that barley fits over the joint when soldered that way it’s as tight as possible
Пікірлер: 21