Thank you for the video. I was doing them all wrong! 😢
@patricejones5949
Ай бұрын
good evening i had a problem with the material by the silver ring melting and i have my heat press at 365 degrees. what can i do to prevent that?
@lindagribbin16
Жыл бұрын
Great video! I was wondering how to do these and if you needed to hang the metal part over the side. Thank you.
@destinykeith6487
11 ай бұрын
How do you set up your design to print the 11 inches?
@robertasprouse8286
Жыл бұрын
Brittany, I followed what you did, other than I used 350 degrees for 60 seconds as that was what someone else had told me to do before I saw your video. However it melted the black that holds the metal ring. I watched your video (thank you greatly) and see that you didn't leave your ring or black area off the side of the heat press but it didn't melt the black; so can I ask where you got your blanks? Maybe it was the blanks that I got?
@robertasprouse8286
Жыл бұрын
Or is it because you use the teflon paper over the butcher paper too that stopped it from melting?
@Merchmadness22
Жыл бұрын
I'm so sorry for the delay. I get most of my blanks from Amazon. I would definitely recommend the Teflon paper. I feel like it really helps, but also, I'm not 100% sure if it wouldn't melt again.
Пікірлер: 8