Just did this on my Acura Integra. It is true. With everthing (harness, dash in car) this is not as easy to do. Also true, manual and auto throttle cable (connection at the pedal) are different. Helpful tips: disconnect the brake light switch (before you begin unbolting assembly). You do not need to undo the brake booster lines, come out to the engine bay and pull it way gently (careful to not bend the hardlines). Lastly, lock up your steering and drop the column. Its helpful if you have a second person to sustain the column a bit. Hope this helps someone. This is how I converted the entire assembly over to manual.
@forcarssake
3 ай бұрын
Thanks for the tips man!
@JakeKwon_01
7 ай бұрын
❤
@MichaelFlare
10 ай бұрын
I don't understand why you replaced just the brake pedal and not the entire brake/gas pedal assembly?
@forcarssake
9 ай бұрын
Because in order to do that I will need to undo the brake booster and I wanted to avoid that. On top of that the throttle cable is different between the auto and manual. So to do the job right you kind of need the manual throttle as well
@IveneverbeenpeedonbyRKelly
5 ай бұрын
I didn't learn how to do this I'm sorry 😢
@forcarssake
5 ай бұрын
Which part did you struggle with?
@IveneverbeenpeedonbyRKelly
5 ай бұрын
The brake/gas pedal as one. I cannot wrap my mind around it. Said f it and cut the brake pedal. I don't get it
@forcarssake
5 ай бұрын
I struggled too to take it out as one, so I pulled the brake pedal out from the top.
Пікірлер: 9