Nja you have to see if the coals are worn out. Moisture often gets inside the oil sand. It's for all cars. It is necessary to open, clean and change the carbons and clean the contacts.
@owenndazizi6737
9 ай бұрын
I didn't see the solonoid engaging
@cgcars3427
9 ай бұрын
When you attach the positive to one side of the wire, test the other side of the wire to make sure you are getting power for sure. If you are getting power then the selonoid may be bad. How old is the car and how many miles?
@dawidkwiecien9938
5 ай бұрын
👍👍👍👍
@balbeppe7462
10 ай бұрын
Ma nel motorino nuovo, non esce l'escursione dell'ingranaggio.😮
@calvinbom
6 ай бұрын
U joined those wires wrong mr
@gilbertkarmun8894
7 ай бұрын
Are they. Inter changeable with tatest model starter
@gilbertkarmun8894
7 ай бұрын
Latest model 😂
@cgcars3427
7 ай бұрын
😂. they should be
@paulaur
3 ай бұрын
No surprise this starter died, because you "banged it"
@cgcars3427
3 ай бұрын
Hey genius, the starter was already bad hence why I took it out of the car. It gets stuck so I banged it and it worked for a little but too old, worn and rusted.
@markleach2177
Ай бұрын
@@cgcars3427yep, if you get stuck somewhere you have to hit it to get home or where you're going.
@patrickjobling8676
11 ай бұрын
Excellent pilgrims 😁pip pips
@kemabosh3588
11 ай бұрын
Solonide was not doing its job on the new stater thou. Only spin but not moving foward
@user-jc6jv6kn2h
Ай бұрын
Why the new one is goat a loop wire on but is not on the old one
@cgcars3427
Ай бұрын
They both are wired the same. May be hard to tell.
@just__dave
10 ай бұрын
Uhhh….
@gaamedjames3394
10 ай бұрын
What??your testing a new one😊
@cgcars3427
10 ай бұрын
What🤨? Just showing the process of testing it and that the test actually works.
Пікірлер: 23