Great video. I've seen many evap diagnostic videos and this is the only one that I've seen that mentions checking for electrical connection.
@johnchase3098
Жыл бұрын
You deserve more likes for this one! Excellent walk through tutorial.
@garyschwalm4842
Жыл бұрын
Awesome job... very good and explained that a 12 year old could understand and learn new techniques. Hats off to you.
@cognac8297
2 ай бұрын
I just hooked up smoke. And took off canister hoses and put my thumb over them. And it holds pressure. It's spewed out when I let off. So😊
@jiyrios7012
Жыл бұрын
Thank you for making it easy for me
@walter.bellini
Жыл бұрын
Nice clear video Just a hint for finding a positive lead, if possible look at the color of the wires coming from the back of the connector, you can sometimes tell a colorful wire compared to a ground wire which sometimes is a solid color.
@nebhosspin1252
Ай бұрын
Great video very helpful. I have engine check on my toyota sienna for charcoal canister. The harness or pins on the canister has 7 pins. Can you advise how to check this please? Thks
@twizz5727
Жыл бұрын
Great video! no BS. Very clear Thank you
@adenlove9207
2 жыл бұрын
Excellent video and highly appreciated,question to be raised if the Vent Shut Valve faulty do I have to replace the whole Evap.Canister or only the Vent Shut Valve
@precisiont5188
Жыл бұрын
I also want to know.
@ifixeditmyself1926
6 ай бұрын
Excellent!
@spelunkerd
2 жыл бұрын
I'm not sure if I'm understanding your remark correctly at 2:23. Are you saying this vent control valve (what Honda call the canister vent shut valve) is normally closed when the ignition key is on? So it must open when purging, or whenever the car is shut off?
@domingodeanda233
2 жыл бұрын
Oct-22-2021, 1st. That was pretty damn good, thanks for sharing your knowledge with us.
@alstevens44
2 жыл бұрын
how do you check the control side
@gueguense8258
Жыл бұрын
I tested mine and when I pump it, it holds vacuum.
@rapinncapin123
3 ай бұрын
I had 2 do the purge. Additionally, I replaced my vent valve last night just because
@markherring3513
Жыл бұрын
To close the evap soldenoid manually with vehicle off, could i simply run a wire from negative battery terminal and connect it to the ground pin of evap solenoid under the truck and then run a wire from the positive terminal on the battery and touch the positive pin on the solenoid?
@precisiont5188
Жыл бұрын
Is this procedure the same with all vehicles?
@EndlessXConcertgoers88
2 жыл бұрын
Wondering can this part be clean with wd40? or you need to replace the EVAP Canister Vent Shut Valve?
@precisiont5188
Жыл бұрын
I want to know this too.
@LoveLikeaHurricane
Жыл бұрын
Curious what fuse it would be for the s2000 if it is a fuse?
@strahinjicban4682
Жыл бұрын
Can i turn off this valve (plug out wire) to try is there any changes...can i drive car few minutes like that to try???
@fishawk90
Жыл бұрын
So the valves closes when the vehicle is running & Vent when it's park?
@r2fredi5
2 жыл бұрын
hi does the white wire need ground or signal ? thanks
@joshuaskaplan
2 жыл бұрын
If the valve is stuck open, do the gasses that escape become flammable in the vacinity of the canister on the car?
Пікірлер: 30