Hello and welcome to the episode, today im going to show you how to remove and install a high flow air filter on a 2020 Honda NC750X.
Help the channel and Buy Me A Coffee: www.buymeacoff...
You dont need an additional tools only the ones provided inside the manufactures tool kit, you will find a screw driver and a Allen wrench
first thing you should do is remove the battery cover as shown
this will allow you to gain access to the lower air filter cover screws
remove the left panel has shown, the front end is clipped in so carefully pull it away giving it a slight wiggle
now do the same for the right side
here you can see it hooks in at the front
next thing you need to remove is the centre panel, this is held in with these plastic push rivets, push them in half way and the rivet will prise up
in total there are 6 holding these on, 3 each side
there is a hidden one inside here
now remove the silver screw on the left
pop out the three rivets on the right side,
now remove the silver screw
lift the left side and make your way to the right
once both sides are lifted now you can pull the centre part towards you because its clipped in under the dials, be careful here move the bars from left to right to wiggle the panel out, the plastic is soft and can flex if you need to.
Here you can see its one complete part
now remove the centre lock panel as shown
remove the centre lock
pop out the air sensor, its only a push fit and will easily come out
here you can see there are 6 screws holding the air filter lid in place
carefully unscrew all of them
now lift out the air filter lid, the filter is attached to the top part
its clipped in you can use a screw driver to pry it out
here is a k and n high flow air filter, if its red in colour then its pre oiled, if not make sure you buy some air filter oil and apply it first
here is the stock filter against the high flow filter
install the parts as shown, be careful not to trap any wires, especially the air flow sensor we pulled out earlier
now push the flow sensor in
install the locks
make sure the cables are not kinked and routed correctly
install the centre panel, clip the front in first then clip in the side section
install the silver screws and then the rivets
clip in the painted panels
install the battery cover
before closing the lid check both locks function correctly using the Allen wrench as shown
Thanks for watching!!
Follow me on socials:
Instagram: / nicks_episode
My gear:
Boots: www.urbanrider...
Gloves: www.urbanrider...
Helmet: www.infinitymo...
Jeans: www.ebay.co.uk...
Негізгі бет How to | The hardest Job on the NC750X, Air Filter/Cleaner Removal!!
No video
Пікірлер: 143