Awesome video! You made this super easy 🤟 And yea my factory belt it hugging the left of the sprocket
@JQUICK21
18 күн бұрын
Thanks for this! After I took my wheel off and then the tire I took it to a local guy to put a new tire on it. When I got home and put it on the bike I had a hard time adjusting the way I wanted it. Was not trying to get the belt to stay in the middle.This makes it look a lot easier. Right now mine is all torn apart. Every plastic panel is off....everything. Getting new forks for it. I might not get it back together till next spring the way it is looking. While the plastic is off I am painting some of it. Been doing a lot of work on this house and so the bike will be last on the list......
@Kahuna_550
18 күн бұрын
@@JQUICK21 Dang!! Hope you get her back together soon. Try and get that Cyclepedia manual to help you out.
@DannyCoolBeanss
18 күн бұрын
Does the belt adjuster need to be loosened to adjust the belt alignment?
@Kahuna_550
18 күн бұрын
@@DannyCoolBeanss No, the left block for belt tension can be set tight. If you just want to adjust the belt alignment your axle nut needs to be loose/hand tight so the right block can move.
@DannyCoolBeanss
18 күн бұрын
@@Kahuna_550ah ok, makes sense. What’s the tq spec for that axle nut?
@Kahuna_550
18 күн бұрын
@@DannyCoolBeanss 88-103 Ft lbs. I just do 95
@1904991
17 күн бұрын
Did you experiencing problem of noise drive belt cos its rubbing outside wall of front pulley?
@Kahuna_550
17 күн бұрын
@@1904991 No, just a rear wobble at speed. Like tire was off center.
@君鎂
16 күн бұрын
NO...the C 19.2mm too tight , 20mm~21mm is good /按照 kymco維修手冊去調整的皮帶緊度,約在15000公里後,皮帶會開始發生異音
@Kahuna_550
15 күн бұрын
@@君鎂 Havnt seen anything regarding 20-21. Even the Kymco service manual. But yes if 19.2 is too tight you'll know by the belt making a noise, then I'd loosen it a bit more till it stops.
@君鎂
15 күн бұрын
@@Kahuna_550 taiwan 現在沒有人會按照kymco服務手冊的說明去調整皮帶緊度,因為太緊了,如果你 C 調整至 18.8mm,甚至會連驅動軸和後輪圈軸承都拉壞...
Пікірлер: 13