I own several Smith &Wessons and the ViceSmith is an indispensable tool. A must have for proper gun care.
@wmwhite6266
2 ай бұрын
Thank you for taking the time to share. I have a 586 that constantly needs tightening & didn't know this tool exists.
@MrMechudo94
2 ай бұрын
It worked for me! Thank you so much!
@Chaosmos_1349
7 ай бұрын
Thank you, totally fixed my issue. Cylinder was hard to eject, tightening fixed it right up.
@benb5960
5 ай бұрын
Fixed my issue. Thank you 👍
@oceanaxim
Жыл бұрын
Thank you for sharing that! I have never seen or heard of this tool. What is your resource?
@bluephantomfury
Жыл бұрын
I got mine from gunsmithertools.com but they seem to be out of stock at the moment. There are a few other tools out there, Brownells has one that is just as good but make sure you get the right one for your revolver. www.brownells.com/tools-cleaning/gun-tools/action-frame-tools/extractor-rod-tool-for-sw/
@bluracer766
4 ай бұрын
Is it important to grip the rod as close to the spring as you can ?
@bluephantomfury
4 ай бұрын
I like tightening it as close as possible to where the threads start for better control. You can feel the difference, say holding a drinking straw stationary on your left hand and then turning/winding/twisting it on the far side of the drinking straw with your right hand. Apply enough torque and the whole straw will start to deform/collapse. If you move closer to the point you are turning, you have less torque being applied to the entire rod and just to the area that needs the pressure.
@efrainrodriguez6067
10 ай бұрын
Maestro donde se puede comprar esta herramienta muy importante para aflojar la baqueta extractora externa.
@bluephantomfury
4 ай бұрын
I got mine from gunsmithertools.com but they seem to be out of stock at the moment. There are a few other tools out there, Brownells has one that is just as good but make sure you get the right one for your revolver. www.brownells.com/tools-cleaning/gun-tools/action-frame-tools/extractor-rod-tool-for-sw/
@edbigtruck
Жыл бұрын
Is it common for it to come loose My 986 does
@bluephantomfury
Жыл бұрын
Might want to check to see if it’s cracked and causing it to unscrew, but it could just be turning itself depending on what ammo you are using. You may also use purple thread locker, not the blue and certainly not red.
@edbigtruck
Жыл бұрын
@@bluephantomfury, doesn’t appear to visually seem cracked And I only use factory ammo, I don’t reload.
@edbigtruck
Жыл бұрын
@@bluephantomfury I purchased this tool from Midway USA it worked great.
Пікірлер: 15