How _not_ to tint your car's fog lights. ... You don't need to push/tuck the tint so far in. That will make it more difficult to get a clean cut around the lens. You don't want any part of the tint on any part of the back side of the housing because it will be dirty and not stick. That will cause the tint to peel prematurely. Never do any job half-a. _Patience is key!_ In this video, you did not even lay down the tint all the way. Never cut until it is properly applied! (The cut should have been much better. You don't cut into the "groove", you cut along the edge of the lens.) You can use tape to remove protective layers on the tint film. NOTE: Fog lights are usually easy to remove. It's been two years. I assume you are better at this. :-) To whoever: _Never tint any lens except on fog lights. Safety first!_ If a person does not care about their own safety, oh well. But the safety of others is paramount!
@aisboom3
2 жыл бұрын
Show us how to change kia K3 horn
@adreyan512
3 жыл бұрын
Do for me leh
@ianfann
3 жыл бұрын
Haha sure no probs, u go buy the tint first then I help u do
Пікірлер: 5