Pressure Advance, what is it, what does it do and how do we tune it. In this video I'll be answering all of those questions.
*Since recent firmware change, it is necessary to issue a 'restart' command after changing any settings or following any calibration procedures.*
Pressure Advance Klipper Page (Copy commands): www.klipper3d....
Square Tower stl: www.klipper3d....
Commands Shown On Screen:
SET_VELOCITY_LIMIT SQUARE_CORNER_VELOCITY=1 ACCEL=500
*Direct Drive*
TUNING_TOWER COMMAND=SET_PRESSURE_ADVANCE PARAMETER=ADVANCE START=0 FACTOR=.005
*Bowden*
TUNING_TOWER COMMAND=SET_PRESSURE_ADVANCE PARAMETER=ADVANCE START=0 FACTOR=.020
Affiliate links (If you purchase something after clicking any of the below links I may earn a small commission at no cost to you. This is a great way to support the channel)
*Creality Sonic Pad*
UK: www.geekbuying...
US: www.geekbuying...
Everywhere else: www.geekbuying...
Discount Code: NNNCRESONPAD
Amazon
amzn.to/3AiYtwD
Discount code: 10NTDPJE
*Other Sonic Pad Videos*
Sonic Pad Review: • Creality Sonic Pad - T...
Sonic Pad Basic Series
Part 1 - Connecting to a Creality 3D Printer: • How To Connect A Creal...
Part 1a - Connecting to a non-Creality 3D Printer: • How To Connect A Non-C...
Part 2 - Completing initial setup: • Completing The Initial...
Part 3 - Starting a print and UI Tour: • Starting A Print With ...
Part 4 - Controlling remotely and WEB UI: • How To Control Your So...
Part 5 - Connecting a camera and tinelapse videos: • How To Connect A Came...
Sonic Pad Intermediate Series
Part 1 - PID Tune • How To PID Tune With T...
Part 2 - E-Steps/Rotational Distance • How To Tune E-Steps/Ro...
Part 3 - Slicer Settings • Slicer Settings and Pr...
Part 4 - Sending Prints From Slicer/Images On Screen • How to Send Files To Y...
Part 5 - Input Shaping - • Tune Input Shaping Wit...
Part 6 - Pressure Advance - • Video
Part 7 - MACROs - • Video
Part 8 - Max Acceleration - • Maximum Acceleration T...
Part 9 - Mid-print Filament Change - • How To Complete a Mid-...
Other
Firmware Update September '23 - • Creality Sonic Pad Fir...
Creality Sonic Pad - How To Update Firmware Without Losing Everything! - • Creality Sonic Pad - H...
..............................................................................................................................................................
BUY ME A COFFEE
If you're enjoying my content, why not consider supporting the channel by buying me a coffee?
Even very small amounts are greatly appreciated and re-invested into bringing you better content.
www.buymeacoff...
You can also use the KZitem 'Thanks' button above if you prefer.
...............................................................................................................................................................
Негізгі бет How To Tune Pressure Advance With Your Sonic Pad - Sonic Pad Intermediate Part 6
Пікірлер: 184