Use a 5/8" 6point socket to take blade. I have this same mower and it takes about 1/2 Qt. of oil. Return the blade after you sharpen it and it rotates Counter Clock Wise.
@jerrysoutherland662
4 жыл бұрын
Would you check the valve clearance in the tuneup sense it's a overhead valve engine.
@dannyhenson1448
4 жыл бұрын
I have a riding how do you replace governor
@norge696
4 жыл бұрын
That's not an easy job. Gotta pull the whole engine off and remove the sump cover.
@Jim-ie6uf
4 жыл бұрын
Danny Henson are you sure it’s bad? did you adjust it correctly? Replacement is quite the job.
@lawrencecarroll2031
4 жыл бұрын
I just replaced the governor on my 18 hp, Briggs, vertical shaft. I found fnaguitarplayer9 You Tube video's really helpful. It's a lot of work, but, not difficult to do. good luck.
Пікірлер: 14