Good idea, I had purchased the CSPower servo and Surpasshobby, the CSPower have lower gear reduction but are too slow and very noisy so I'm using the Surpass 19g servos
@Violator-RC
7 ай бұрын
Yes. It is a bit noisy.
@LUAPRC
7 ай бұрын
Malupit ka talaga lods 👍
@Violator-RC
7 ай бұрын
Salamat sir.
@daijoubu4529
7 ай бұрын
You should have left the servo driver in place, the receiver is not meant to directly drive a motor like that, the pins can only sink very little current, the proper way to do this is to disconnect the gears from the potentiometer and glue it in place or find the middle position resistor value of the pot and replace the pot with a resistor divider
Пікірлер: 6