My idle want that i install a module named machine but first i dont know why and second thing is that when i want to install it i receved a error message Can you help me please
@natashasmith7182
10 ай бұрын
Is it normal for the range to be less than 180 degrees, around 160 or so? Is there a calibration process?
@Core-Electronics
10 ай бұрын
Some servos may have more or less range, check the data sheet of your servo model to see what it is, 160 sounds like a weird number though 🤔
@btigenie
9 ай бұрын
Following code line by line and when I get to run, I get an error saying "no module named 'machine'". It is a requirement of micropython-servo .... what package or plug-in is it?
@comical24
7 ай бұрын
have you got micropython installed on your pico? if not, go to the bottom-right part of thonny and click "install micropython". go through the needful and whatnot, then the machine library should work!
@mannahfarmandforge5225
Жыл бұрын
Hi I'm trying to follow along but in Thornny I cannot find "Micropython servo" package. Any pointers?
@santanukumarpatra2073
5 ай бұрын
it"s micropython-servo
@pcc404
7 ай бұрын
o-ooh i thought rotational servos could be positional
@richardcafe7757
11 ай бұрын
Guide, what guide? Go to where? You're forgetting you're teaching novices. 🤦♂️
@Core-Electronics
11 ай бұрын
Hi Richard, it's in the first line in the description.
@richardcafe7757
11 ай бұрын
@@Core-Electronics Hi, sorry. I'm an amateur model maker trying to get battleship turrets to turn and elevate and I've ended up in an electronic and programming nightmare😱😁 Thanks, I'll re watch it.👍
@Core-Electronics
11 ай бұрын
No worries mate, sounds like a fun project 👍
@richardcafe7757
11 ай бұрын
After my initial outburst (from my frustration rather than anything you had or hadn't done, once again my apologies) I have to say I found your coding, description and explanations very easy to follow and I now understand a heck of a lot more than I did yesterday. Thank you.👍 Could you do or have you done a follow up to this vid covering running two or more servos doing independent movements simultaneously? That would certainly be of great help. Thanks again.
Пікірлер: 15