Nice sign.. I just have a small question about your table extension for you P2. I have the P2 also, and have purchased the Conveyor System, but I have not had a chance to use this so far, but I am wanting to add on to my bench and I just wanted to know how far did your make your table extension? Thank you...
@MonkeyWoodworks
4 ай бұрын
I made a quick knock down setup for my P2. My infeed and outfeed tables were made by cutting a 12" x 6ft board in half. If you check out my video of putting together the conveyor, you can see how I set it up.
@rickpouley7561
4 ай бұрын
@@MonkeyWoodworks Thank you!vI will look up your video! Have a great weekend..
@MonkeyWoodworks
4 ай бұрын
@@rickpouley7561 same to you. Feel free to reach out if you have any questions
@rickpouley7561
4 ай бұрын
@@MonkeyWoodworks Thank you again!
@kaizhongryan
Ай бұрын
Thank you.Can you tell me the length and width of the materials you usually process?
@MonkeyWoodworks
29 күн бұрын
It varies by the customer's requirements
@chiokeelmore6028
Ай бұрын
This video is super helpful. Thank you so much.
@MonkeyWoodworks
29 күн бұрын
Glad it was helpful!
@penworks9983
4 ай бұрын
I don't have a conveyor, so I will live through you! Lol 😆 looking forward to your Ultra review!
@MonkeyWoodworks
4 ай бұрын
hah! Live away Pen!
@Pa_Dave
2 ай бұрын
THANK YOU so much, your videos are great!
@Pa_Dave
2 ай бұрын
So..if the conveyor is not same level as P2 ..how u suggest fix that?
@MonkeyWoodworks
2 ай бұрын
If it is too short, you can put scrap wood under the feet of the conveyor to lift it up to level. If it is too high, you will need to figure out a way to either lower the side tables supporting the conveyor or raise the P2 a little.
@MonkeyWoodworks
2 ай бұрын
You're very welcome!
@ShyneflowLC
4 ай бұрын
I really have to give mine a shot haha
@MonkeyWoodworks
4 ай бұрын
Do it!
@Explosion85
4 ай бұрын
Great video! I discovered this while trying to find a new pizza cutter and I think this settles my decision!
@MonkeyWoodworks
4 ай бұрын
Now I gotta know, which pizza cutter did you go with???!!!
Пікірлер: 19