I watched my dad weld the spider gears in old Fairlane back in the mid 80s for drag racing
@bradfreitag8466
6 жыл бұрын
And on a side note, if you plan to use the rear end multiple times, make sure you don't weld the pin in. If you do, and brake an axle, it's junk.
@TheSleeeman
2 жыл бұрын
just want to point out this is only true on c clip axles
@codyfeatherstone731
Жыл бұрын
Thank you great video answered all my questions
@1GooseGarage
Жыл бұрын
Thank you for watching
@bradfreitag8466
6 жыл бұрын
Another good video guys. Thanks
@bryanmccollum210
3 жыл бұрын
I've done this with a 220 arc welder. I'm surprised a mig is hot enough to get good penetration on high carbon steel. Good job.
@rickmtz7356
2 жыл бұрын
Can this be done to ur daily driver
@travisrifanburg3633
Жыл бұрын
It can be done with anything that uses spider gears. But you're going to eat up tires a lot faster when you turn. The inside tire is turning slower than the outside. Every time you turn a corner you'll hear rubber burning.
@gilbertgurrola539
3 жыл бұрын
ima do this to my c10, great video. one question......why did you cut the cover??!
@MrSours69
Жыл бұрын
How hot voltage and how fast of the wire feed do you need to weld these thick-ass gears up?
@Timeshifter32
4 ай бұрын
Being a welder, just run it hot and slow as possible bro. Migs dont get enough credit for strength. If you do it right, you should never have a problem.
@shawnsderbyden1032
6 жыл бұрын
i would defenetly refill that rear end itll get hot quick and lock up
@codyheath6962
6 жыл бұрын
Shawn Deweese we haven't had an issue yet... I'm sure that may change someday... And if we get a rear end that is worth taking from car to car we will takebetter care of it... Midsize heats dont last more than 10 min here usually.
@NoVacks4Me420
4 жыл бұрын
Thanks for sharing, maybe your welding line speed was too slow, cheers
@josephlaviolette4368
5 ай бұрын
What about cornering? Does this still allow you to turn properly?
@mikehickman3635
5 жыл бұрын
Maybe pull the oilpan out b4 you start weding but ya pretty much👍
Пікірлер: 17