I know leaving the engine down will drain water but j like to mix antifreeze into the miffs. Also put some in my bilge and tilt the trailer down to spread throughout the boat so things don’t freeze…
@tomgordon4395
Жыл бұрын
Very informative video!! I notice you have trim tabs on your boat, can you comment on whether these are really needed on a 20 - 24 ft boat? I'm looking at a boat now and they are a 1K+ option. Thanks again!!
@sweetwaterfishing8931
Жыл бұрын
If you go in the ocean, they are needed. They bring the bow down so the waves are not ponding the middle area of the hull. They also level out the ride. I would highly recommend them.
@PianoUniverse
3 жыл бұрын
Do you fill the fuel separator with fresh gas? And if not does it causes insures starting in the spring. Just got a new Sea Hunt and want to do my own service. Nice video. I live on the great Bay close by...
@sweetwaterfishing8931
3 жыл бұрын
Thank you. Leave it empty over the winter. In the spring, I prime the engine by squeezing the bulb on the fuel line. Never had an issue. Going on 10 years of winterizing this way.
@MattScullyCurran
28 күн бұрын
How to winterize my Colman rv camper
@johndar7862
3 жыл бұрын
Is it possible that the primary fuel filter part you listed is incorrect?
@sweetwaterfishing8931
2 жыл бұрын
This is the factory fuel filter for an f150. Yamaha OEM Outboard Primary Fuel Filter Element 6P3-WS24A-01-00
@stephenmeyer3091
11 ай бұрын
Do you run the motor after changing the oil ?
@sweetwaterfishing8931
10 ай бұрын
No.
@richardc2803
10 ай бұрын
Do you fog it for winter?
@sweetwaterfishing8931
10 ай бұрын
Fogging oil is added to the gas that is run through first.
@hookedonfishing.6021
Жыл бұрын
Do you fog the engine ??
@sweetwaterfishing8931
Жыл бұрын
The engine gets fogged from the oil mixture that is added to the auxiliary gas tank.
@muskyman3238
3 жыл бұрын
You don't fog the engine?
@sweetwaterfishing8931
3 жыл бұрын
By adding Yamaha EFI Storing fluid or and mixture of oil and stabilizer in a separate gas tank, there is no need to spray fogging fluid. I find it easier this way. If you want to spray fogging fluid, there is a small rubber boot for each cylinder. When you remove it, you can insert a red straw attached to the can and spray it directly into the cylinder. There is no way to spray all 4 cylinders at the same time unless you make a manifold out of plastic tubing.
@sweetwaterfishing8931
3 жыл бұрын
You can also remove the spark plugs and spray directly into each cylinder. Replace the plugs and turn the engine over with boots removed so it does not start. My boat is only out of the water a couple months so I don’t bother. If you were storing it for an extended time, this would provide added protection.
@derrickkaseman9843
2 жыл бұрын
Did you make the primer bulb setup your self? You just prime the mixture into the filter and run until it smokes? You want to leave the filter empty after that right? And at the end do you add the stabilizer first then fill gas in to mix it good and you don't start the engine after that do you?
Пікірлер: 19