@@martinrudolf7103 do you recommend advancing the media into the cure zone partially prior to printing without using the take up?
@martinrudolf7103
3 жыл бұрын
@@daniellamiell1253 HP say now its possible to start printing on leading edge. normally it really works but sometimes you need to move it below the heater as before. It doesnt matter if you use the TUR.
@daniellamiell1253
3 жыл бұрын
@@martinrudolf7103 great! Thank you!
@shreejistudioledlive302
2 жыл бұрын
Price
@williammcleod9823
11 ай бұрын
You made a video specifically to demonstrate loading material onto the printer... and you didn't show how you load the material onto the printer. Brilliant 🙄
@user-pw8fm2rz2k
6 ай бұрын
Холдерите са от Старата генерация и въобще не се препоръчват да се използват
Пікірлер: 9