Rebuilding the differential of the Savage Flux Hp. Check this link for removal and installation of the differential from the diff housing - • HPI Learning Lab - Sav...
thanks Rakesh...very informative . well presented 👍
@RakishRc
8 жыл бұрын
Thank you very much Anuj!!
@InTheZone85
5 жыл бұрын
Don't forget to shim your diffs. Minimal side to side play so that the ring gear of the diff isn't slapping the ring gear in the bulkhead. And if possible shim the ring gear so that it doensn't move front/back and slap the ring gear of the diff. A balanced setup=happy teeth=longer life for everything including the bearings. Also those blocks at the end of each spider gear need to have the flat side against the housing and the round side towards the center. This way there's no pressure point on the diff case
@gonzodetroitify
2 жыл бұрын
So right now I think on my ring gear side I have like 5/6 x .2mm’s so when I have the diff in hand I have really close to no coming apart if you see what I mean so my opposite ends of diff have no outward play but they have wobble very slightly and all this and I’ve not yet put the diffs to the truck so I’m now thinking I should have shimmed once the diffs were in the truck to stop that same play
@PalaginMax
6 жыл бұрын
Very useful, thanks!
@RakishRc
6 жыл бұрын
Максим Палагин you're welcome!
@PIZZA_and_NITRO
3 жыл бұрын
Instruction video 100% ❤
@RakishRc
3 жыл бұрын
Thanks!! 👍
@royarsey5429
7 жыл бұрын
it made me panic when you threw all the parts that i need to break down.. its a lot to build,my first time to do this,.. thank you ! ..RC Gods will help me...lol
@RakishRc
7 жыл бұрын
Roy Mariano you're welcome! It does take time at first but once you get use it no problem and it's not very difficult either.
@TargetingXmod_RC
7 жыл бұрын
Nice video. But take note that putting thread lock on plastic will make it brittle very soon. Only apply thread lock to alloy, never on plastic. That diff cup seens plastic by the look of the video...
@RakishRc
7 жыл бұрын
Thank you for appreciating my video. Its an alloy diff case.
@jackscott5144
3 жыл бұрын
Does anybody know if this diff cup fits on the hpi trophy truggy as mine keeps eating the plastic diff housing ????????
@astasuleo
7 жыл бұрын
very nice video. A small mistake. You have overfilled with silicon and there is no breath at high speeds. The result is to have a leakage from the case and with probably damage the core gears.
@RakishRc
7 жыл бұрын
Thank you very much for commenting and appreciating my video. I do understand your point but so far I haven't faced any problems with the differential since the rebuild.
@jurgenfd
6 жыл бұрын
Thanks for the insights. Rakesh, does the diff get hot while driving hard? I would guess so with this much oil. Ain't a few drops enough?
@tktk4273
4 жыл бұрын
I know this is retarted but are both sides of the diff supposed to spin or just the left side?
@RakishRc
4 жыл бұрын
Both sides spin..opposite when not in contact with surface and together when in motion on surface.
Пікірлер: 19