Great video. I have a 948cc Morris is this a modification that should be done for this engine? may I suggest a butterfly shaft re-bushing episode, that would be fantastic.. As always great videos and topics. TX
@ACDodd
6 ай бұрын
I have already done a spindle rebushing video a few years ago. Any road based engine will benefit by having a vacuum take off for a vacuum advance mechanism. It is usually worth 6 to 8 mpg.
your positioning, and drilling, are possibly more accurate than factory were.
@Slack3rDav3
6 ай бұрын
would you do this to only one if using a dual carb setup?
@ACDodd
6 ай бұрын
Yes same as the factory
@kevwills858
6 ай бұрын
Nice vid but why use a Centre drill on alloy when you have an x n y axis ? also no gloves on those hairless hands with a flame ? Would a heat gun work n be safer ?
@ACDodd
6 ай бұрын
Centre drills do not wander like a normal drill bit can. I am confident around flames and that particular flame you can actually put your hand through it and you won’t get burned, clearly if you held it there that would be different and silly!
@kevwills858
6 ай бұрын
@@ACDodd I Wonder how far they would Wander in an axis Drill press ?🤔😄
@stuwhite2337
6 ай бұрын
Great work. What's the benefit of taking that vacuum off the carb as opposed to the manifold like on my late model MGB ?
@ACDodd
6 ай бұрын
It reduces the vacuum signal at idle and hence improves the hydrocarbon reading massively. Thus the engine runs cleaner for emissions testing and you still get the benefit of vacuum advance when cruising.
@stuwhite2337
6 ай бұрын
@@ACDodd so basically at idle it runs less advance?
Пікірлер: 15