In this vid I make a backplate with an MT3 fitting for my new 5in 4 jaw, to fit my tailstock. This will allow me to clamp work between two 4 jaws - to hold long irregular work especially if it has hollow ends. The finish on the work could be coaxial or eccentric. For example, the setup could be used to clean up a petrol pump eccentric on a camshaft with a toolpost grinder (if I had one - maybe another project in the future). #TAILSTOCK4JAW
- 3 жыл бұрын
HS43 Making a tailstock 4 jaw fitting for my Harrison 140 lathe
- Рет қаралды 92,693
Пікірлер: 174