A very long and boring but detailed disassembly video of Huben K1 v2 where I also discuss fine tuning you can make on the gun and explain points of leaks and how to detect them.
Timestamps:
The most important disassembly 0:00 until 17:00
How to reassembly the barrel and align the magazine probably 17:00 until 24:00
How to improve trigger first and second stage 24:00 to 31:00
he explains why he has not taken the action block apart so far 31:00 to 32:00
Explanation how to make the safety harder or lighter to configure 32:00 to 33:00
he explains how the magazine seal is working in the gun and why it is a good design even with Revolver like gap 33:00 to 35:00
Possible leak with the magazine and how to fix it in theory 35:00 to 37:00
Explanation how the magazine is working with the pin to set the stage for the next round and how the action is working several other explanations in this as well like how to remove the plastic part that makes sure no pellets can fall out from behind the magazine where the pellets are loaded 37:00 to 47:00
Possible leak he explains how the magazine rotation is working with the pin and that the pin can have a problem with an O-ring and several other possible leaks 47:00 to 52:00
Possible leak explanation that sometimes the regulator gauge can cause problems but it’s not the gauge it could be an O-ring inside 52:00 to 54:00
Possible leak explanation on how the power adjustment works with the brass part and why it is unlikely to fail but some O-rings are hard to replace in case of failure or a problem 54:00 to 57:00
It could be a failure but it’s very unlikely to have there a leak he explains exactly how the valve for the opening and the valve chamber is working in power adjustment and the plastic seal that is necessary in function before and after the shot 57:00 to 1:01:00
Possible catastrophic part failure if there is something wrong behind the back plate where the spring is in the opening valve and the explanation why it is almost impossible without huben or a retailer to get a replacement for it 1:01:00 to 1:06:00
Possible leak Inside the opening valve chamber there is an O-ring and a seal that can cause leaks but needs special tools to replace the O-rings correctly in place 1:06:00 to 1:08:00
Regulator chamber and high-pressure chamber explained a stage before anything else before how to depressurize the high-pressure chamber because the regulator should be not be under pressure anymore at this point for save disassembly or work 1:08:00 to 1:10:10
Regulator pressure can be adjusted by washers how to have more pressure but less precise regulation of the pressure or less pressure and more precise regulation of the pressure 1:10:10 to 1:14:00
Негізгі бет Huben K1 version 2 - disassembly
No video
Пікірлер: 268