Thanks for commenting and watching! I have since sold this chainsaw and I’m going to buy a 545 Mark 2 in the near future!
@dkat1108
Жыл бұрын
WOW you had to pump your fuel that much ? Mine is brand new too and I only pumped it like 6-8 times and it fired right up.
@wrightdefenthaleroutdoors
Жыл бұрын
Yea, it took it a lot of pumps to get going but wasn’t too much of a hassle. Put about an hour on it cutting a pine and it worked flawlessly!
@dkat1108
Жыл бұрын
@@wrightdefenthaleroutdoors hey are you using pump gas with the oil added or from the Husqavarna pre-mix ?
@wrightdefenthaleroutdoors
Жыл бұрын
@@dkat1108 Husqvarna pre mix. I normally run echo red armor.
@MrCervin221
Ай бұрын
Can’t get mine to start? Did the same thing! Any advice?
@wrightdefenthaleroutdoors
Ай бұрын
@@MrCervin221 thanks for watching and comment! Chainsaw may be flooded. Pull plug and if wet, it’s flooded. If dry, may be fuel delivery issue.
@FunHobbies225
Жыл бұрын
can u tell me how many turns the h and L screw on in ? trying to tune my saw
@wrightdefenthaleroutdoors
Жыл бұрын
Thanks for watching and the comment! I would generally start with turning both screws in all the way and then back out 1.25-1.5 turn.
@FunHobbies225
Жыл бұрын
@@wrightdefenthaleroutdoors I meant the saw u have that’s new what’s it’s settings from the factory
@wrightdefenthaleroutdoors
Жыл бұрын
@@FunHobbies225 from factory they tend to be more lean which means they’re probably 1.25 turned out rather than 1.5. But I no longer have this saw. Had to sell.
@FunHobbies225
Жыл бұрын
@@wrightdefenthaleroutdoors oh ok right now mine is set at 1 3/4 L and 3 H
@wrightdefenthaleroutdoors
Жыл бұрын
@@FunHobbies225 if it dies out once started then L may need adjusted. If it idles fine but won’t rev up then H may need adjusted.
Пікірлер: 15