This was ridiculously helpful. I followed your steps, and I was able to take off the tires VERY quickly. And thank you for mentioning the key at the end. I am not very mechanically inclined. I didn't know that was in there, and I KNOW I would have lost one or both of them.
@RealManSkills
6 жыл бұрын
Happy to help. I have seen people forget to put that key back in and wonder why the axle is turning but the wheel isn't! Thanks for watching.
@JESSEPINKMAN74
9 ай бұрын
@@RealManSkillsope! I should have watched till the end....I think I lost mine!!
@RealManSkills
9 ай бұрын
@@JESSEPINKMAN74 No worries. You can buy square stock at the local hardware store and make your own.
@JESSEPINKMAN74
9 ай бұрын
@@RealManSkillsI actually found it! 🤣 Really surprised by that! good to know that I can get another one fairly easily. Thanks for the great video!
@RealManSkills
9 ай бұрын
@@JESSEPINKMAN74 Thanks for watching!
@deweyferguson3295
Жыл бұрын
Great demonstration, piece of cake, slice of pie. Thanks for sharing
@RealManSkills
Жыл бұрын
Happy to help!
@stevehood10
Жыл бұрын
Thanks heaps for the video, I had all the tools ready to go so I didn't need to keep getting up and kneeling down when I discovered what I needed next. You just saved an old Melbourne guy a LOT of back pain, cut down on the swearing too, very much appreciated.
@RealManSkills
Жыл бұрын
Thanks for watching!
@patrickg7058
8 жыл бұрын
Thank you so much _Sunday morning in Bonville country NSW Australia helped out my hostess to get the mower going for her son!
@RealManSkills
8 жыл бұрын
Happy to help! Thanks for watching.
@stephaniesummers7452
Ай бұрын
Thank you!
@LKalyuzhny
4 жыл бұрын
Thanks for detailed instructions. Great job!
@RealManSkills
4 жыл бұрын
Thank you for watching.
@LKalyuzhny
4 жыл бұрын
@@RealManSkills Tommorow will apply it. Thanks again.
@LKalyuzhny
4 жыл бұрын
And i did!. At least removed, installed repair kit which holds rear axle and ...had some beer. Today, i need just put wheels back. Nothing else. Tbhanks.
@RealManSkills
4 жыл бұрын
@@LKalyuzhny Cool!
@MrCoder101
5 жыл бұрын
What is the diameter of the axle?
@The.Alabama.Woodsman
2 жыл бұрын
Very helpful. Thanks for taking the time to make the video. I put a little anti-seize on my when i put it back together. Hopefully easier off next time.
@RealManSkills
2 жыл бұрын
Yes, I started to use anti-seize more often myself. Thanks for watching!
@FoodAsMedicine7
Жыл бұрын
Thanks, perfect instructions.
@RealManSkills
Жыл бұрын
Thanks for watching!
@itomas
6 жыл бұрын
Thanks for the video! I already had taken off the wheel and put it back on (with an inner tube)...but the mower only drove for a little while and then wouldn't go forward or reverse. I didn't know about that key! Apparently I lost it along the way. So, after watching the video, I jammed an allen wrench in the slot and it works fine now. (I WILL get the proper key though.)
@RealManSkills
6 жыл бұрын
Just had a guy call me about that. "When I put the tire back on, it won't move!" I told him about the key and sure enough, he found it on the ground under the tire. Thanks for watching.
@itomas
6 жыл бұрын
Well, before I resorted to using the 3/32" allen wrench for a key (and after your video), I picked through every blade of grass in the lawn and every stone on the gravel driveway...couldn't find the key. It was odd that the mower was able to cut the entire 1/4 acre before it wouldn't drive anymore. Right after I had originally put the wheel back on, it wouldn't go...but then it lurched forward and was fine for a while. Twice more, while I was mowing, it wouldn't drive and then finally lurched forward each time...until the final time when it wouldn't go at all. That's when I watched your video and voila!...allen wrench!
@RealManSkills
6 жыл бұрын
I am not sure if that allen wrench can cause damage to the shaft but you might consider changing it out with a square key. The local hardware store usually sells "square stock". If you buy the correct size, you can cut it to length and make your own key. Thanks again for watching.
@RealManSkills
5 жыл бұрын
Happy to help!
@JulianHamlin
Жыл бұрын
When you remove the retaining clip … I can’t see what you’re doing! Which not are you using the flat head screwdriver etc on?
@JulianHamlin
Жыл бұрын
Which bit
@GeneralChangFromDanang
Жыл бұрын
There should be a slot in the retaining clip that you can stick a flat head screwdriver in. Then kinda twist the screwdriver back and forth and leverage the retaining clip off of the axle.
@LynnHalbert
Ай бұрын
How do you put the tire BACK on with the pin? Do l tap it in with a hammer or...? I am at a loss!
@RealManSkills
Ай бұрын
Yes, after lining up the groove for the key, I sometimes have to lightly tap the key into the groove.
@michaelmayes9532
2 жыл бұрын
Thank you for the know-how!
@RealManSkills
2 жыл бұрын
Happy to help!
@bladedspokes
5 ай бұрын
Great video on how to remove the rear wheel, but didn't show the removal of the rear tire.
@rafaels3552
Жыл бұрын
What inner tube can I use with this?
@PhilGeissler
8 жыл бұрын
Very helpful, thanks!
@RealManSkills
8 жыл бұрын
Thanks for watching!
@balazsstojcsics
5 ай бұрын
Hi Thanks for the video! If one key is missing (one side), the problem will be the same? (Mower does not go.) Thanks!
@RealManSkills
5 ай бұрын
I think that is correct. But I never really thought about it or tested that possibility. Thanks for watching
@balazsstojcsics
5 ай бұрын
Problem solved, mower is moving 😊 Thanks 🙏
@elikaufman8695
2 жыл бұрын
Hi and thanks for great video! How do you do to get the plastic cap back on? hot air?
@RealManSkills
2 жыл бұрын
Sometimes they go on easy enough but sometimes I soften them up with a heat gun or blow dryer. Thanks for watching.
@jeremyr4297
9 жыл бұрын
Thanks I lost a front wheel, and wasn't sure what parts I needed to put it back on.
@RealManSkills
9 жыл бұрын
+Jeremy Rabel I am happy that I could help. Thanks for watching!
@bernardoperrot
Жыл бұрын
Thanks
@RealManSkills
Жыл бұрын
Welcome
@beckymaupin1330
3 ай бұрын
How do you put the tire back on (specifically the retaining clip)
@RealManSkills
3 ай бұрын
The clip fits into a groove. I slide it into place with a pliers. I will make a better video.
@ManBricks
8 жыл бұрын
same huski I had but transmission blew up know got a ferris zero turn
@hillaryclinton4059
3 жыл бұрын
Anyone here find the torque specs on the rear tires of a husqvarna z254f?
@kathleentalbot8039
8 жыл бұрын
no holes on wheel to do what you did so any more tips
@finncampeau4922
6 жыл бұрын
kathleen talbot holes?
@WevertonTonNax
2 ай бұрын
😊
@joannyeager9209
11 ай бұрын
How to fix frame on Husqvarna tractor
@joannyeager9209
11 ай бұрын
How to www
@jasonwest7253
8 жыл бұрын
man I've been stuck tryng to hey my back wheel off this Husqvarna for days. mine moved freely for about an inch when pulled then stops like there's some kind of lock preventing it from coming off. Any info would be greatly appreciated.
@RealManSkills
8 жыл бұрын
In case there is a burr or large build up of rust on the end of the shaft, you may have to break out some sand paper or file. Sand or file around the end of the axle. You may also have to use a product like "PB Blaster" to break up some rust. Hope you get it worked out soon - try not to shoot the D&$%^#N thing!
@jasonwest7253
8 жыл бұрын
well I just went and got a puller and some eyebolts and I'm heading home now to try it. Will let you know
@melchormorenojr8608
7 жыл бұрын
What is that key called?
@RealManSkills
7 жыл бұрын
It's called a "key". It's about two inches long. Check out part # 532123583 from Husqvarna. Thanks for watching.
@finncampeau4922
7 жыл бұрын
It is called a key way
@eugeneoreilly9356
3 жыл бұрын
They are called Woodruff keys.You will find them on many mechanical applications including holding the timing belt pulley to the crank on an Opel Vectra where they usually break and wreck your engine.
Пікірлер: 64