It was a while ago, but i used 49T877-0025 and a 3/8" spacer ring to align the belts. To do it again i would of cut 3/8 off the shaft and threaded the crank deeper for the clutch if need be. It still ran like a champ when i had to sell it in 22 in a move. It had over 1400 hours and it was solid. Briggs made a great motor for sure on this one.
@tepongoagatas1758
Ай бұрын
I’m looking forward to my project again thanks to you . I also have the same mower but with the Honda engine . What part number Briggs did you use ?
Пікірлер: 2