Nice quick troubleshooting. Ive been watching a lot of your videos. You seem like a great tech, thank you for all the extra time to take us along for the ride
@D2DNYAC
Жыл бұрын
Thanks for watching my friend
@princeprince9902
Жыл бұрын
Thanks for the video from Florida
@D2DNYAC
Жыл бұрын
Thanks for watching my brother
@wd8557
Жыл бұрын
Good thing about them boards are, their are a few points you can ohm out and if it's bad your done. If that back board is bad, change the power board also because that's what took it out.
@D2DNYAC
Жыл бұрын
👍
@sdsd4284
Жыл бұрын
Always look forward to your videos even though im not on that level yet ,i understand the megg was just a bit confused why did the voltage dropped from 250 to 0 and what would u expect to see if it was good ?
@D2DNYAC
Жыл бұрын
Good question my friend , the test voltage would remain the same or have only a slight deviation lower if the compressor windings were good.
@D2DNYAC
Жыл бұрын
Regarding the voltage dropping from 250 to 0 you will need to know ohms law for that to make sense!
@sdsd4284
Жыл бұрын
Okay, great stuff as usual my friend ,looking forward to the next one .
@thesilentonevictor
Жыл бұрын
Experience at its best
@D2DNYAC
Жыл бұрын
Thanks for watching my friend
@JDT738126
Жыл бұрын
Awesome videos brother, that job looked like a pain in the ass! How high is that condenser rack?
@D2DNYAC
Жыл бұрын
Its on top of a 11 floor building and then add another floor or 2 for the platforms that was built on the roof for all the condensers
@JDT738126
Жыл бұрын
@@D2DNYAC gotta be a stud to do that work then keep up the good work, love your videos I watch them til the end.
@JDT738126
Жыл бұрын
The noise filter board in the back is a common PCB to fail. I have replaced them on units that are 10+ years old
@D2DNYAC
Жыл бұрын
Hmm I didn't see that on the schematics or wiring diagram!!!
@wd8557
Жыл бұрын
@@D2DNYAC That's what some people call even Mitsubishi, the noise filter board. Sorta like someone calling a thermostat a controller. However on that back board their is a resistor some where, when you ohm it out you should read 20. You don't it's bad period and that's usually because the power board took it out. Replace both.
@tabresztabu562
Жыл бұрын
Tq bro
@D2DNYAC
Жыл бұрын
Thank you for stopping by
@floyddavis2095
Жыл бұрын
Hey, can I dm you , I have a question or two
@D2DNYAC
Жыл бұрын
Sure
@D2DNYAC
Жыл бұрын
Whats app!
@floyddavis2095
Жыл бұрын
What about instagram? I don’t have a what’s app, I thought you had a ig page?
Пікірлер: 26