Thank you for doing this kind of stuff … were allot alike you and me :)
@tomhendricks316
2 жыл бұрын
Thanks Pete, I think there are more of us out there than we think. Thanks for watching!
@Eagle_1985
2 жыл бұрын
@@tomhendricks316 you bet ! …. Im working on something else on my bobcat mg 50 , but figured id watch your video in case i need to service my cylinders some day
@1tgibbon1
3 жыл бұрын
nice to use the homemade spanner wrench
@stevea6722
Жыл бұрын
A 6 point socket is a lot less apt to round off a nut on high torque applications. The "hard plastic" may be teflon, try soaking it in hot water for a few minutes to soften it. It should shrink back after cooling.
@tomhendricks316
Жыл бұрын
Thanks Steve Good feedback! Thanks for watching!
@elffirrdesign2063
7 ай бұрын
The outer piston seal is PTFE 15% glass(PS1400). Yep Teflon with glass fibers in it. Heat shrink is made out of it so try a little heat from a hot air gun if you over stretched it when you pulled it over the piston to get shrunk to fit the cylinder and be careful not to over warm it for the fit over the piston... work with some haste to get it in the groove . Go from the bolt end on the piston to avoid over stretching. The machinist vise is a neat trick!
@kennikuhlmann-clark9860
Жыл бұрын
Wouldn't it have been better to crack the gland open with the spanner while the cylinder was still mounted on the Bobcat?....
@tomhendricks316
Жыл бұрын
Yeah that's a lot more stable. Thanks for watching!
@jamesfranks545
3 жыл бұрын
Those nuts are torqued to around 500 ft pounds lol.
@tomhendricks316
3 жыл бұрын
I know...I finally got it to say yes! Thanks for watching!
@patstuder7750
2 жыл бұрын
why fix if not leaking
@tomhendricks316
2 жыл бұрын
If I remember correctly, I think the other side was leaking so I rebuilt both sides. Thanks for watching!
Пікірлер: 14