The hole at the back is a drain hole for the PTO clutch compartment. It usually has a cotter pin in it. If oil is dripping out, your PTO power shaft seal/flange is leaking. I just changed this seal on our 2010.
@radozeman
4 жыл бұрын
Ah ok.
@NickEnderby
Жыл бұрын
That seal hard to change?
@chriscowan1419
Жыл бұрын
Do you have to split the tractor to change that seal?
@bobhoneywell3
3 жыл бұрын
The rod on the clutch side of the tractor (2010) when depressed disengages the hydraulic system to facilitate easy start in extreme cold weather.
@beaustude4583
6 жыл бұрын
The foot pedal on the left, leading to the lever down below is a bypass to the hydraulic pump. It is used for cold starts. It allows the engine to turn over easier by not having to pump cold oil. As a side note, I have heard of the pump housing cracking on a VERY cold start while NOT using the bypass.
@radozeman
6 жыл бұрын
Ah ok!
@mrjata
3 жыл бұрын
I know this is old, but the lever you questioned is a hyd pump disconnect for starting in cold weather. Lift he lever up and engage the arm, and depress the pedal.
@scottmcclenahan6681
3 жыл бұрын
Thanks, I have a JD 401b, still trying to figure out all the levers
@graydust4985
6 жыл бұрын
Thanks Randy. I watched every video on this. When they have the Gas and Steam show here in Allendale I have to look at all the old John Deeres.
@radozeman
6 жыл бұрын
Cool!
@andrewkennett940
Жыл бұрын
Is the filter on the passenger side where you were putting in hydraulic fluid?
@backwoods1816
6 жыл бұрын
The hole is in the p.t.o. clutch housing. This should be a dry place. Mine has a cotter pin in the hole. If oil is leaking out that hole it has to be leaking from the rock shaft hydraulic assembly or the seal on the p.t.o. shaft coming from the engine,through the transmission.
@radozeman
6 жыл бұрын
Ok
@fragile1976
4 жыл бұрын
What do you call the two plugs/ports just behind the brake pedals? It looks like a black hydraulic hose connects the two of them together. I have a 4010 that is leaking from one of the plugs, unsure what to call it when shopping for repair parts. I'm looking at it with the video paused at 8 seconds.
@radozeman
4 жыл бұрын
Those at least on this tractor are for a loader and they are just regular pipe fittings at least on this tractor.
@highacresfarm3420
6 жыл бұрын
Is this going to be a complete restoration or just fixing up some odds and ends?
@radozeman
6 жыл бұрын
Just fixing up odds and ends
@J12345cats
3 жыл бұрын
Any idea where check valve is for power steering? I got a 2010 can’t get power steering to work. That random valve you asked what it is disconnects the hydro pump so it’s easier to start! Thanks
@radozeman
3 жыл бұрын
I do not with this tractor.
@JeffreyMyers_
6 жыл бұрын
Those some styles came with a trans disconnect. 4020s from what I saw you can pull a lever and you cannot move the tractor. Is there a lock on that pedal? And that other leak is prob rockshaft seals.
@radozeman
6 жыл бұрын
No lock on the pedal that I can tell. I’ll have to try and see what it does
@NickEnderby
Жыл бұрын
Did u ever figure out hole underneath?
@radozeman
Жыл бұрын
No I don't think so
@jmiller3605
8 ай бұрын
The hole underneath is a weep hole where the pto clutch lives. It's suppose to be dry.
@123cheetacat123
6 жыл бұрын
I believe the hole is a weep hole, so you can see if the seal is leakin on trans! :) Kinda like weep hole in water pump ! :) That little lever may be like parkin brake maybe gewd luck :)
@jerrygieseke6553
5 жыл бұрын
How do you change front hydraulic filter on 2010
@radozeman
5 жыл бұрын
I'm not aware of a front hydraulic filter, as far as I know it is located in the lower portion of the transmission, under the cover
@DarkerGreen
Жыл бұрын
That lever is to disengage Everything for an easier start, then push the clutch
@rebeccaroberts5130
5 жыл бұрын
The hydraulic fluid should be checked with engine warm and lifts relaxed and motor at idile
Пікірлер: 43