Thank you sir.. Finally I got to learn what I was searching for..
@raviupadhyay3252
4 жыл бұрын
Great video, very easy to understand, Thankyou Sir.
@Marineriderr
7 жыл бұрын
your videos are very helpful sir
@wasim4017
4 жыл бұрын
Really super...still many engineers don't know ..how its working..let them see your video and learn ...
@Marinemechanik
11 жыл бұрын
Yes they might differ depending upon manufacturer.
@RajeshKumar-mt3pg
5 жыл бұрын
Thanking you sir perfect explanation
@sundarbala999
11 жыл бұрын
easy understanding video, thank u sir
@yuvaraj1386
Жыл бұрын
Great work
@sewwandawijekoon3621
2 жыл бұрын
thank you very much
@Siddhantverma-lj4yv
4 ай бұрын
Very good explanation sir thanks a lot
@nazarsaad3377
9 ай бұрын
thanks it was very useful
@bharanidharan6323
4 жыл бұрын
Awesome sir
@deone786
11 ай бұрын
Nicely explained...
@denimiletic5619
11 жыл бұрын
good video
@kirkdsouza9410
3 жыл бұрын
When we are loosening the stud/bolt sill contract right ?
@SandeepSharma-di7bt
11 жыл бұрын
does lifting limits of m/e & a/e jacks differ even if they were used at same pressure of 900 bar
@shivaprakash9922
4 жыл бұрын
What's the purpose of slackening the nut while removing?
@Av-vi5vs
8 жыл бұрын
thank u sir. still I have one doubt man b&w says while openings hydraulic nut, we have to full tight the jack on studs full but they open 1/2 turn. why it is.while tightening we have to full tight the jack, no need to loose y such.
@Ablissfool
8 жыл бұрын
The half turn loosening of the jack by half or so turn while opening, lifts the jack up, and therefore facilitates the lift of the nut when we open the nut. Whereas when we tighten, since the movement of the nut is downwards during tightening, there is no need to loosen the jack.
Пікірлер: 21