Thank you. There are many things to consider when designing a small system and maintaining others' existing designs.
@engineeringpod
7 ай бұрын
Very true! You're welcome
@mylesharris8569
23 күн бұрын
I need to change a valve off a 1400 gallon while oil still in it. Any ideas without draining tank fully and excess wasted oil
@engineeringpod
20 күн бұрын
Which valve exactly?
@MoneshwarSutar010P
9 ай бұрын
How to calculate the sheet thickness for hydraulic tank reservoir
@engineeringpod
9 ай бұрын
Depends on the size of the reservoir, the amount of fluid, the type of hydraulic system, there is usually no need for going overboard on the thickness as the reservoirs in open loop hydro static systems are not pressurized vessels.
@agounnabeil8901
11 ай бұрын
The engine rotates 1600 per minute and its power is 10 horsepower. What is the appropriate pump?
@engineeringpod
10 ай бұрын
This is unfortunately something that is not so simple to be done in the KZitem comment section :D
@agounnabeil8901
11 ай бұрын
Engine power is 380
@engineeringpod
10 ай бұрын
This is unfortunately something that is not so simple to be done in the KZitem comment section :D
@agounnabeil8901
11 ай бұрын
بالنسبة لمحرك 10ph ...ماهي المضخة المناسبة...وشكرا
@engineeringpod
11 ай бұрын
It depends on a lot of factors such as the needed RPM output of the motor, the needed power of the motor, etc...
@agounnabeil8901
11 ай бұрын
Engine power is 10 HP. Here is the appropriate pump
@agounnabeil8901
11 ай бұрын
Sir, I want to create a plastic press with a body width of 2.4 m and a length of 4 m. Help me, thank you
Пікірлер: 20