We will leave out the rate of torque for some strange reason.
@danaevans3524
7 ай бұрын
On the Toro 4000 with the ZT4400 torque filter bolt to 200 to 300 in-Ib.
@jonathantaylor6926
Жыл бұрын
My Ferris z3x has these pumps but the vent port is an 11mm and it’s in a terrible location for a service item.. the bolt in this video was more like 3/4 so something must have changed.
@johnsagraves14
3 жыл бұрын
I have the exact mower you're working on. It would have been nice of you to mention that you can't easily access (unless you have smurf hands) the port vent plug without removing the transaxles. It would literally add 4 seconds to your video, making it an even 3 minutes, but saving me a lot of aggravation. I see a half dozen locations you could have placed the vent plug to make it much more accessible without removing each transaxle. Good grief.
@drake23hector
2 жыл бұрын
How did you end up doing it? I’m stuck at this spot.
@timpope1221
2 жыл бұрын
Those vent plugs are extremely difficult to access so when you finally get a wrench on it do not completely remove it just crack it open a couple turns this will allow it to vent, hope this helps.
@gregpendleton4957
4 жыл бұрын
You think you could have put the vent port plug in more accessible spot? Impossible to get out where it is located on the Farris z3x. Just saying.
@damorej416
4 жыл бұрын
Greg Pendleton same with the gravelys. Make it look too easy with the transaxle out of the mower🤦🏻♂️. Would like to see how it’s done with it on the mower
@denverstaib1025
Жыл бұрын
Bobcat makes it super easy to access on the zt-6000&7000 series zero turns. Not really hydrogears fault it’s hard to get too on other mowers. The oem should make provisions for it.
@danaevans3524
4 ай бұрын
@@damorej416 Toro 4000 with the ZT 5400 Very hard & tight to get to the vent plugs!
@SteveKluver
2 ай бұрын
It's up to the mower manufacturer, as to how *they* build the machine/frame around the transmission. Send *them* an email about this. Maybe *they* will change it on the next year model?
@pmtips4482
2 жыл бұрын
I have a Scag Cheetah with the ZT5400s, I can remove the vent port plugs but it's a disaster every time I change fluid as I can never catch it just right, resulting in an overflow mess. You now include two threaded fittings and two short lengths of transparent hoses with each oil change kit..... I was hoping this video showed their purpose. It did not.
@Scooter_cash
2 ай бұрын
Why was he running the blades in a building to begin with?
@edwarcandy4648
Жыл бұрын
Hydro gear purge
@8th3IST
8 ай бұрын
what size is the socket to remove oil filter cover?
Пікірлер: 16