The scraper on that thing saved me so much grief removing the floor.
@1dandandy1
Жыл бұрын
They are amazing. A friend of mine invented it.
@leannajulin8046
2 жыл бұрын
Can’t wait to see the transformation
@jamieoliver9071
Жыл бұрын
Just wondering how common this is
@jamieoliver9071
Жыл бұрын
Hey, got a question, when you ripped all the core out of that hull did you notice some spider cracking of the gell coat on the areas that were tough to remove?
@rumnboats7612
Жыл бұрын
I did not, I did however expose previous repairs that turned into holes. I would think if the gel is old and/or thin possibly already full of stress cracks and there was really alot of flex when removing that would happen. Take a good look at the glass under the coring after grinding and consider adding a layer or 2 before coring again. In this case I repaired the holes and put a layer of 1808 over the entire inside of this hull before adding coring/transom. Have videos of entire process so far.
Пікірлер: 9