Worked perfectly to follow your video to fix our 04 Tiburon turn signal. Thank you sooo much!!
@sargetester99
4 жыл бұрын
You got skillz, mad skills my friend
@victorblamar99
Жыл бұрын
Thank you very much, I just did this on my car and now it works Greetings from Spain!!
@Aer0n113
Жыл бұрын
Holy f.. ty i thought i needed a "1lt" bit the 3N1S work too! nice to know!
@1874jamboman
3 жыл бұрын
Tanks for posting this video, was able to get the relay replaced and restore my signaling indicators.
@markbutler6539
4 жыл бұрын
Awesome video 👍
@PeterSpitzer-vc4rn
2 ай бұрын
I have an 08 tiburon. I have 2 little relays where you just replaced one. Do you know which one us for the left turn signal?
@chriss.431
2 жыл бұрын
Thank you!!! You saved me so much money! God bless you!
@angieghostuforick1645
3 жыл бұрын
Thanks glad I found your video couldn't figure out what was wrong thanks again
@markpurcell8075
4 жыл бұрын
Thanks for this! The easiest way to get the relay out is with a heatgun, desoldering with a solder sucker can be difficult and might damage pads when removing the part. Hold the board upside down by bridging it between two books either side, move the heatgun around the pins in a continual motion until the relay drops out. Be careful of thermal shock to the PCB, it's best to preheat the board to around 70 deg C beforehand, and wait for the whole board to cool down fully before cleaning up or touching the pads.
@narf444
2 жыл бұрын
do you know if one of the other relays is for (un)locking the doors via remote control? that doesn't work anymore. (the remotes work, the central locking mechanism works, they are programmed to the car, but they won't open the doors). thanks for the great video.
@chriss.431
2 жыл бұрын
Thank you! Can you please tell us what the third relay above the 2 is for???
@NeoS-fq6ex
2 жыл бұрын
Hi Andy, thank you for the great video! I have a question, so in your vid it is the right turn signal, but for my car - it is the left turn signal. Does this mean that I should replace the other relay, or is it the same relay you had to replace? Thank you in advance.
@andyl7935
2 жыл бұрын
Hello Neo, I’m glad you found the video helpful. I wish I had a clear answer to your question. Unfortunately I am not certain if that relay controls both left and right turn signals. I think it does control both because it has 10 pins , so I believe it is a double relay in one case. However it may be wise to just replace both relays mentioned in the video to be sure. Hopefully this helps. Good luck!
@bobbaxter952
3 жыл бұрын
I just replaced the indicator relay on my fiat BCM,my initial problem was all turn signals on the driver side weren't working,now after replacing the relay 'both' sides of the car my indicators aren't working,plus the car no longer recognises my keys!!Careful doing this stuff!!
@violalee1223
3 жыл бұрын
any updates to your signal stuck problem? My 2003 Tiburon has the same problem. I just ordered the relay from mouse.ca and am hoping to do it myself. Does anyone have any tips for me? Andy?? I've done some soldering before.
@Askonnito
2 жыл бұрын
I had same issue with the key. You probably didn't disconnect battery while doing this as I did, I left bcm outside the car for it to discharge and after 3 days went back to life and car's drivable
@Lilly-up2km
Жыл бұрын
Hi! Same with mine. Did you do it? and did it work? 🤞Did you change out all 3? is it three? I hope you did! 😁 I may try it...have had bcm issues for years! 💛✨
@musicaatuantojo7199
13 күн бұрын
Tengo una duda el relé qué estaba a la par que funcion tiene, en mi caso ninguna luz da ni prenden ni en el tablero tendría que cambiar los dos relé qué están ahí juntos
@andyl7935
12 күн бұрын
@@musicaatuantojo7199 how do I translate this reply?
@andyl7935
3 күн бұрын
You might have a different problem then. Have you checked all of the fuses?
@josepalacioscatolico8504
3 жыл бұрын
Thanks, I try when I get relay.
@flint6873
2 жыл бұрын
ay bro I have two questions! 1. Where did you find that 10 pin relay for the right turn signal light 2. can I fit a relay from a different year Tiburon (coupe) to my 2003 1.6 thx In advance!
@Aplayasworld
3 жыл бұрын
My left turn signal doesn't blink I gotta replace the relay like that too right?
@andyl7935
3 жыл бұрын
I believe that one relay is in fact a double relay . It has 10 pins and most relays only have 5. So I am pretty sure that it covers both the left and right turn signals. Good luck!
@Aplayasworld
3 жыл бұрын
@@andyl7935 yeah they both light up when I turn on the day time, but the left doesn't blink when I want to turn left.
@Aplayasworld
3 жыл бұрын
Is that relay in the back too?
@sargetester99
4 жыл бұрын
I find it better to solder 5 wires to the board that are long enough to reach outside the box, and mount a relay socket. Because, if it broke once, it'll probably break again.
@markpurcell8075
4 жыл бұрын
The problem is actually contamination inside the relay causing the contacts not to open, there's another video around showing this. That was the problem with mine (it's a common fault apparently!). I fixed mine by taking the relay apart, removing the contamination, and resealing the relay.
Пікірлер: 29