From www.justanswer...
JustAnswer Customer from San Antonio, TX: Hi, I have a Bosch dishwasher that keeps stopping and beeping mid-cycle.
JustAnswer Customer from San Antonio, TX: The first time it did it I noticed the filter at the bottom of the dishwasher was dirty.
JustAnswer Customer from San Antonio, TX: After cleaning it, the dishwasher continued working fine.
JustAnswer Customer from San Antonio, TX: A few months later now, it started beeping mid-cycle again, but not the filter is clean.
JustAnswer Customer from San Antonio, TX: *now the filter is clean
Pearl Wilson: Assistant: Do you know the model of your Bosch dishwasher?
JustAnswer Customer from San Antonio, TX: Yep.
JustAnswer Customer from San Antonio, TX: It's SHP65T55UC/02 It doesn't give me an error codes
Pearl Wilson: Assistant: How long has this been going on with your Bosch dishwasher?
Pearl Wilson: Assistant: What have you tried so far?
JustAnswer Customer from San Antonio, TX: It's been an intermittent issue for a few months.
Pearl Wilson: Assistant: Is there anything else the Appliance Expert should know before I connect you?
Pearl Wilson: Assistant: Rest assured that they'll be able to help you.
JustAnswer Customer from San Antonio, TX: I've cleaned the filter and pulled the little housing up by the filter to make sure the impeller isn't clogged.
JustAnswer Customer from San Antonio, TX: I've also checked the drain line to make sure it isn't kinked going into the garbage disposal.
JustAnswer Customer from San Antonio, TX: I haven't pulled the dishwasher out.
Scott the Fix-It Guy: Home Appliance Technician: Thanks for waiting.
Scott the Fix-It Guy: Home Appliance Technician: If you open the door when it stalls is there still a lot of water at the bottom?
JustAnswer Customer from San Antonio, TX: Yep.
JustAnswer Customer from San Antonio, TX: If I reset the cycle by holding down the start button for 3 seconds, the dishwasher will pump all the water out.
JustAnswer Customer from San Antonio, TX: There aren't any error messages
JustAnswer Customer from San Antonio, TX: There is always 1:11 left in the cycle.
JustAnswer Customer from San Antonio, TX: I checked the filter and impeller.
JustAnswer Customer from San Antonio, TX: It spins without lots of effort.
JustAnswer Customer from San Antonio, TX: The drain line has a high loop that looks to be correctly installed.
Scott the Fix-It Guy: Home Appliance Technician: Thank you,If you open the door 20 minutes into the cycle do you get a big plume of steam coming out?
Scott the Fix-It Guy: Home Appliance Technician: It might be stalling because it doesn’t heat up the water.
Scott the Fix-It Guy: Home Appliance Technician: How high does the water get in relation to the round filter handle after 5 minutes of filling?
JustAnswer Customer from San Antonio, TX: the water does get hot.
JustAnswer Customer from San Antonio, TX: I'll have to check the water level after filling.
JustAnswer Customer from San Antonio, TX: I haven't looked at that.
JustAnswer Customer from San Antonio, TX: I ran the dishwasher.
JustAnswer Customer from San Antonio, TX: The tub fills up to the top of the filter handle.
Scott the Fix-It Guy: Home Appliance Technician: Perfect water level and the water is nice and hot.
Scott the Fix-It Guy: Home Appliance Technician: Something else is making it stop.
Scott the Fix-It Guy: Home Appliance Technician: Does it say anything on the display when it stops?
JustAnswer Customer from San Antonio, TX: Nope.
JustAnswer Customer from San Antonio, TX: No error messages.
JustAnswer Customer from San Antonio, TX: I pulled out the dishwasher last night to see if something looked clogged.
JustAnswer Customer from San Antonio, TX: I noticed there was a fair amount of drain hose behind the dishwasher.
JustAnswer Customer from San Antonio, TX: I pulled it into the cabinet under the kitchen sink (they are adjacent) to make sure there isn't a kink.
JustAnswer Customer from San Antonio, TX: The line itself looks good.
JustAnswer Customer from San Antonio, TX: It doesn't look like it's clogged or have debris in it.
JustAnswer Customer from San Antonio, TX: I've run the dishwasher twice and so far it's drained okay.
JustAnswer Customer from San Antonio, TX: But, it didn't stop every time before.
JustAnswer Customer from San Antonio, TX: It seems to be an intermittent issue.
JustAnswer Customer from San Antonio, TX: I've also checked the garbage disposal to make sure it wasn't full.
JustAnswer Customer from San Antonio, TX: It's clear.
Scott the Fix-It Guy: Home Appliance Technician: Great thinking, sounds like sometimes the drain doesn’t work, maybe due to a filled up garbage disposal .
Pearl Wilson: Assistant: If you have a home improvement or appliance question and want to chat with an expert now visit justanswer.com/ythi
Негізгі бет I have a Bosch dishwasher that keeps stopping and beeping
Пікірлер