I made a bed with an ejector pipe to make the inside of the car full flat.
The skeleton of the bed was made from a 28mm ejector pipe that I bought at a home improvement store.
I used a special pipe cutter to cut the ejector pipe.
The floor of the car has many irregularities.
I made it while measuring the length of all legs so that it would be horizontal and there would be no steps.
The floor board uses the wooden board bought at the home center.
I drew a urethane mat on a wooden board, wrapped it in a leather sheet, and fixed it with a tacker.
Installed vehicle model
Suzuki Wagon R (MH22S)
I would be grateful if you could subscribe to the channel.
/ @inakura
#Wagon R
#bed
#Vandwelling
MH22S
#Elector pipe
#Full flat
#Dentan
Негізгі бет Тәжірибелік нұсқаулар және стиль I made a bed with an ejector pipe to stay in the car
Пікірлер: 11