I make Spoked Steel Wheels in an Industrial Style, using Rebar for the Spokes. I love anything industrial and if it has rebar in it then it is even better, and this project is one of my favorites, maybe because of the bit where I bend the flat bar into rings, using just a hammer, I have done this before, but I have never tried to video it before.
It was a fun rebar project to make and I hope you found something of use in my video or at least found it entertaining.
The wheels are 215mm (8.5 inches) High, the flat bar is 6mm thick (1/4 inch), and 50mm wide (2 inches) The rebar is 26mm across the widest part.
The main tools I used, were a MIG welder, angle grinder, drill, Hammer, and bench vise.
Tools / Supplies, I often use are.
Marking out Tools
Markal Silver-Streak Metal Marker Round: amzn.to/3mTJDHt
Milwaukee 4pk Inkzall Black Ultra Fine Point Pens: amzn.to/2WKKpeE
Milwaukee Inkzall Jobsite Fine Point Black Permanent Marker 12 Pack: amzn.to/3kHrXfo
Locking Pliers - Vise Grips
MILWAUKEE 10” Locking Pliers, Curved Jaw: amzn.to/3zzJH2u
Milwaukee 6" Long Nose Locking Pliers: amzn.to/3jyVLeS
Milwaukee 6” Locking Clamp Regular Jaws: amzn.to/3jB94eI
KNIPEX Tools Long Nose Grip Pliers: amzn.to/3ByD1SP
Magnets
Magnetic V-Pads Kit, Magnets On Both Pad Face & Bottom: amzn.to/3DCya4W
Mini Magnetic Fabrication Square Magnets Angles: 30°, 60°, 45°, 90°: amzn.to/2WN9Fkr
“L” shape Corner Square Magnets 12°, 90° & 60° Angle Setting: amzn.to/2YaZXsU
My camera set-up.
Canon EOS M6 Mark II Camera 15-45mm Lens: amzn.to/3DNnn83
VideoMicro Rode Compact On-Camera Microphone: amzn.to/3QkUBnK
Camera Tripod Vanguard Alta Pro 2: amzn.to/3yB8hP5
The Brand of the Drill bits, and cutting/flap discs, is "Alpha" If you can't get them at your local hardware shop, here is a link to Alpha Tools: alphatools.com.au
As an Amazon Associate, I earn from qualifying purchases. This means that if you click on one of the product links, I’ll receive a small commission. This helps support the channel and allows me to continue to make more videos like this one. Thank you very much for your support!
►►Subscribe to our Channel for more videos ►► bit.ly/2ULxLJog...
Always use all the correct safety gear, and use your tools safely, I am not a good role model for this.
Hope you found something of use in my video or at least found it entertaining.
Gavin Clark DIY
Негізгі бет I make Spoked Steel Wheels in an Industrial Style, using Rebar for the Spokes - Rebar Project
Пікірлер: 480