In this video I started out using the Monarch to do the job but that didn't pan out so I took the next easiest route and used the Thompson Surface Grinder. Surface Grinders are not generally thought of for removing much metal but they sure can and I don't even have an aggressive stone on mine. This video contains real time of taking 3/8" of material off this yoke. It was way quicker than trying to come up with a better setup to hold it and I was not going to hard after it because i had to use transfer washers to get the part to mag well anyway. I hope you enjoyed the spark show and thanks for Watching!
- Күн бұрын
If One machine Fails the Job Try Another One: Modifying a Transmission Yoke To fit Another Use
- Рет қаралды 6,963
Пікірлер: 60