3 hours of quad testing in a public park next to houses with that noise... They must have loved that 😉👍
@gimbalair
Жыл бұрын
I did think the same, a very helpful video though, I'd just rather it wasn't done in such an obvious place, if any of the neighbours new the regs they're be out there in a shot.
@stilesfpv1382
Жыл бұрын
No more loud than a bunch of kids haha
@jg3d
Жыл бұрын
That 450 pack was holding the Voltage good during the current spike loads, sounded more like the bottleneck of the setup might be the props unable to keep its shape during higher load/ RPM !? Nice work 👍
@andykirby
Жыл бұрын
KZitem processing is slow tonight guys, sorry we are stuck in 360p at the moment, hopefully it'll resolve itself soon. 🤷🏻♂️
@Pict8kr17
7 ай бұрын
Very helpful. Adding remote ID and I do not want to solder anything. Using these batteries I can now run it off the balance port. Thank you!
@FPV-TV419
Жыл бұрын
Great battery review! Some good saves with the tree! 😆
@KirbyMiller
Жыл бұрын
I found that you can very easily push out the metal pins on the side brackets to remove the original plastic springy clips, then replace the pins (without the plastic clips and springs). That will allow you to put a thin battery strap through those side arms. The strap will just slide between the side piece and the now exposed metal pin. That seems to work very well and I can use an 850mAH HV Lipo and stay below 250g total. I hope I explained that in a way that makes sense. I just thought to try it this morning but I'm sure I'm not the first to do it.
@KirbyMiller
Жыл бұрын
though I think for those flatter shaped LiHV batteries you are using in this video, the side posts may be too high for the strap to make contact with the top of the battery (I wrote the above comment before watching most of the video). And in that case, you would have to cut the plastic sides a bit shorter. I guess it depends on whether you would ever want to go back to the iFlight batteries. But even so, you could still use those with a strap
@kostyako6329
Жыл бұрын
Hi Andy, How do you make the goggles indicate low battery with a voice to you? Is it some setting in Betaflight or goggles? Couldn't find it.
@James_Innes
Жыл бұрын
I'd call that move a wing-over maneuver or if you want to feel like a ww1 French flying ace you can call it a Chandelle. I'd be interested in what a snow boarder in a half pipe would call it?
@gamlemann53
Жыл бұрын
Nice video Andy! How many volts can the motors take? Without getting burnded?? The best from LB1NH in Oslo 🙂
@andykirby
Жыл бұрын
Hi Arild, thanks, the voltage limit will be on the speed controllers (esc's) its normally 6S (25-27V) but if you go too high with this high KV motor you'll lose efficiency and power and the motors will just get hot and burn up without producing any more useable RPM.
@FrenchDoorFilms
Жыл бұрын
Can I use 4s Lipos with an xt60 to xt30 adapter?
@TheMadmacs
Жыл бұрын
looks amazing, i wonder what set up would be best for a naked gopro and maybe gps? to get under 250g i'm thinking.
@oliverkersh2010
9 ай бұрын
Im getting a iflight defender 25, was going to get the dji goggles (new one) / controller but I've seen other controllers out there and i see youre not using the dji controller. Which controller would you recommend? Thanks
@michaelmason5459
Жыл бұрын
Hi, watched a item about using Toroidal props on boat how efficient and more power and ultra quite, Lincoln University have designed some for drones that seem to have same quality as for boats.
@rclxmg
Жыл бұрын
hi i never had an fpv and was looking to buy one, do you think this is too hard for a first fpv drone experience or not? i should go to an avata first? thanks
@patrickbonin137
Жыл бұрын
Learning curvre for me but interesting to watch..keep going im learning...when are you going to join the Ukrainian 🇺🇦 drone team..luv the video Andy,one day you must to do a complete drone video..the bits you need,and some expert advice so knobs like me can keep up ..I liked the video..well done.but I hate the prop noise.sounds like a dentist drill..lol.🤣💖
@andykirby
Жыл бұрын
Hey mate! Good idea about the complete drone video, that could be useful for some like yourself who wants to understand more. It can be a deeply technical hobby but you are a smart guy 😁
@gimbalair
Жыл бұрын
So if you are just whooping/cruising and not doing tricks and flips the heavy battery 'tames' it a bit, or is it better to limit the throttle in BF. is it plausible a naked could fit on with a 450? and be under 250?
@bindestrek
Жыл бұрын
How big of a battery could you fit it before the weight to power ratio stars "degrading" the experience
@rufuscollis303
3 ай бұрын
If anybody knows how to bind this drone I'd really appreciate any advice. I bought a Defender 16 and a Defender 25. The 16 no longer flies after I've been trying to bind it to the goggles. I still can't find any bind button on the Defender 25 and I don't want to poke anything inside again incase I break this one also. I wish I had bought the DJI drone, this nano button binding nonsense is totally frustrating... and in my case fatal.
@netwrkspider
6 ай бұрын
could you please share the PID, rate profile settings?
@nigelrendall
Жыл бұрын
So I managed to strip the proprietry 550 MaH battery and you can use the top part of the cover only with a 720 MaH HV Lipo that clips in perfectly keeping the battery secure without 3D Printing anything. Still all below 250 grams. Shame I cannot share the photos I have.
@andykirby
Жыл бұрын
Amazing, feel free to post on our discord in the FPV section! discord.gg/EeVggnUegS
@FpvSage
Жыл бұрын
Thanks man I needed this. Going to buy an extra defender pack just in case
@barnesandrewj
Жыл бұрын
Use mushroom tape! Hard velcro!!
@nigelrendall
Жыл бұрын
Are the batteries that you used 3S??
@andykirby
Жыл бұрын
4S
@nigelrendall
Жыл бұрын
@@andykirby Just been looking at the iflight battery wondering if you could remove the 550 MaH inside, clip off the connector and slip in a 720MaH and cover with Black nasty tape. There seems to be 2 screws at the bottom (Connector Side). This would then enable the use the iFlight restraing clips.
@FpvSage
Жыл бұрын
What about lihv 850?
@robknight9406
Жыл бұрын
The battery is a dealbreaker unfortunately… Can’t see if it is swelling
@chrisnrs354
Жыл бұрын
its not a regular lipo
@robknight9406
Жыл бұрын
@@chrisnrs354 aha thanks
@leefrohock
Жыл бұрын
360p, shocking. I thought i had Cataracts !!!🤣🤣
@andykirby
Жыл бұрын
Has it sorted itself now?
@leefrohock
Жыл бұрын
@@andykirby yep 👍
@EnglishTurbines
Жыл бұрын
You can hi volt charge any Lipo, it just shortens their lifespan....Your not doing our hobby any favours making that din with houses so close by Andy, just saying mate...They already hate us...including the CAA...😳😳😳😏🇬🇧
Пікірлер: 44