How did you figure out the Baud rate and other settings?
@FrancescoF
Жыл бұрын
Trial and error, but those are very common
@thomasatkins
Жыл бұрын
Also had the hub already been setup via the app or was this pre-setup
@FrancescoF
Жыл бұрын
This is before the Setup. Never paired or connected to a network.
@thomasatkins
Жыл бұрын
Hi, I am trying to get the uart to work. I am using a flipper zero in its uart to usb bridge mode and have the pins connected to its ts &rs&ground and have it connected to a terminal. I double checked the pins, and set the baud rate to 115200. Did ypu have to do anything else to get it to work?
@thomasatkins
Жыл бұрын
I also have verified that if I connect the transmit and receiver of the flipper zero my setup is logging the values I type
@FrancescoF
Жыл бұрын
I used a very simple FTDI UART adapter, maybe they disabled the update in a more recent firmware release, the one I look at was from the very first batch. Maybe try swapping TX and RX just in case you hooked them up wrong
@tuttocrafting
Жыл бұрын
Is a TTY available? Wondering how the various radios are used!
Пікірлер: 10