it is important to follow the maintenance routines, clean the combustion chamber after use. It is also important to change the stator in the SDP every 6 months and check/replace the rotor if it is worn.
@ALASAN76
2 жыл бұрын
Subscribe already chief thanks for sharing the video specially for the new seafarer, I'm an early retired seafarer that's my handle before when I was 4th engineer
@ercuevsvlog1978
2 жыл бұрын
Wow galing idol ingat lage sana may matunan kami.idol pa shout out naman ako heheh
@markdayag754
2 ай бұрын
wow ang galing mo idol👏 ilan ang sludge pressure and air pressure mo idol kapag sludge nalang ang sinusunog mo? automatic ba na mag sludge nalang sya or need pa ilagay dun na yes para sludge only?
@boybangastv3079
2 жыл бұрын
Thank you sir
@tonyrice797
2 ай бұрын
Hello sir, i have problem with this incinirator, i have alarm on main display near the flue gas value and it is not going, but temperature is normal. I can start the insinirator and it's working, but inscription "alarm" continue blinking and i cant remove this by pressing button list→acknowledge. Please answer me
@norvictoruntalan6343
2 жыл бұрын
good day sir .. seaman din po ako at same po ng incinerator ang barko nyo smin may alarma na replace battery ung samin. san po nklgay ung battery na paplitan ? slamat po sa pagsgot..
@wellyahmad590
2 жыл бұрын
I want to ask sir, how do I set the teamtec incinerator so that the y settings don't return to all zero?. I have a problem that the plc battery has been replaced and the y settings are all zero,, after I set it a few minutes later the settings returned to zero. please teach sir how to set it so it can be saved. Thank you
@widars
Жыл бұрын
Backup battery at the PLC. Do not turn off main power at the Incinerator/PLC when you have battery replacement message on display. Replace battery asap.
@wellyahmad590
2 жыл бұрын
Good day sir.. I want to ask sir, how do I set the teamtec incinerator so that the y settings don't return to all zero?. I have a problem that the plc battery has been replaced and the y settings are all zero,, after I set it a few minutes later the settings returned to zero. please teach sir how to set it so it can be saved, thanks sir
@chiefelrich6663
2 жыл бұрын
It is PLC program. It will comeback to original setting after 5mins once you change.You cannot do about it. IT is from maker's program.
Пікірлер: 11