Thank you for explaining the rotation of the motor. I just blew out two push rods on a 6.7 Cummins motor. What a night...😥
@truckingpaysthebills5394
Жыл бұрын
Trust me i feel your pain 😥
@konbat3468
4 ай бұрын
👌👌👌
@jeffl107
Жыл бұрын
nice job. Did you just install a new head or was that part of a rebuild. I have a lot of blowby on my engine. I think it might be from my air compressor pressurizing my crankcase, or atleast I hope it is. If not then rebuild is probably gonna be next. I had no blowby until after a shop installed a jake brake on it for me. but my air compressor also started leaking oil about the same time.
@truckingpaysthebills5394
Жыл бұрын
I had the head service at a machine shop then i reinstalled it. Take you truck to the shop and let them check it out and see if they can figure out what's causing the high blowby
Пікірлер: 9