Hello from Australia! Love the build, doing one myself currently (similar engine into different datsun) can I ask, what your distributor is? And does it enable you to run coil on plug?
@TomNicklasSand
Жыл бұрын
I've removed the distributor and I'm running a SR20 crank angle sensor on a 3d printed standoff/adapter. The stock 360slot wheel inside was replaced with an aem one so it works better with aftermarket ecu's. I'm running toyota yaris coils.
@lito_0050
Жыл бұрын
amazing truck bro! new suscriber! u swap the intake manifold? because i was now this is a carburate moto ajjaa
@TomNicklasSand
Жыл бұрын
Correct, it's a z20e intake manifold
@oranjutang3136
3 жыл бұрын
hey, I'm a 14 year old kid looking into starting a project car. The 720 is one of my favorite chassis' out there, and I would love to know what engine that is?
@TomNicklasSand
3 жыл бұрын
Z24ET
@Barret_Radtke
4 жыл бұрын
does the flex pipe help with engine vibration?
@TomNicklasSand
4 жыл бұрын
It's more of a cheat so I didn't have to be 100% accurate with the pipe angles when I made it since I didn't have anything more than an angle grinder back then 😉
@Barret_Radtke
4 жыл бұрын
@@TomNicklasSand ok i was just wondering too my self if it would help reduce engine vibrations from making its way into the cab of my truck.
@TomNicklasSand
4 жыл бұрын
@@Barret_Radtke Nah that has more to do with the condition of your engine rubber mounts :)
@Barret_Radtke
4 жыл бұрын
@@TomNicklasSand yeah thats what i think but my dad said it wasn't them.
Пікірлер: 11