I had one of these many years, exactly the same model as the one featured here, using Rega RB300 tonearm and I think a Goldring cartridge. It was an excellent turntable. I had no troube at all with bearings, suspension, it was a pleasure to listen to. The only mod I did was to lose the felt mat and replace with a cork mat, I don't think it made any difference.
@apollomemories73
10 жыл бұрын
That was as much use as an ashtray on a motorcycle - I really need to see how you balance the plinth.
@MrMts9
5 жыл бұрын
i found it easier installing an XA spring kit because this one I purchased for my ES-1 table has shorter studs...once installed the tonearm spring needs to be tightened up almost halfway the other two almost to the end resulting in a tbar that never centers in the cutout...it sits to one side or other..im still experimenting...it sat fine with the old springs
@proteus1
9 жыл бұрын
Can you still get parts for theses turntables? Can theses decks, if fitted can they sound as good as linn
@theoabrams2079
3 жыл бұрын
How much of an improvement did this make ?
@BrooklynNYCigarKing
19 күн бұрын
My belt comes off on my AR turntable when on 45 RMP. Any suggestions?
@MASTERVETEAM4
12 жыл бұрын
Hi, many people uses linn springs to replace the springs, are those springs differents ( I'm guessing these are from Merrill, you also sell high duty springs on your website. I suppose you would use them for mounting a Sme V on a heavier turntable like td-126/127 or something like that? Anyway thank you for this very informative video!!!
@colinsmall8170
2 жыл бұрын
The platter bearing on this was poor quality,that should have been addressed first.
@MrBill-250
10 ай бұрын
The Merrill Chassis installed in this video has its own bearing.
Пікірлер: 9