Hey i just got these camber plates for mk6 aswell , was wondering what u used to cut tophat off the towers? Also after the cut u made were u able to fully slide plates to max negative? Any help would be appreciated. Very Clean jetta btw !
@TheVWGarage
Жыл бұрын
I didn’t cut anything. As in the video, I set the camber than installed them.
@nesamina123
Жыл бұрын
@@TheVWGarage oh ok, my mk6 has the tophats on towers which restrict me from sliding it to the max negative unless its cut.
@dominikausten7726
5 ай бұрын
What plates did you use
@payton_5
3 ай бұрын
Can these go to -8 camber?
@TheVWGarage
3 ай бұрын
That I can’t answer. You can check the IE website to see.
@Stancylon
Жыл бұрын
bros tweaking over -2.5 degrees of camber lmfao, get some stretch tires and thatll drop you like an inch, move your spring up and lower the coil until your strut is about to hit your front control arm and then loosen your spring seat and lower the spring and youll be low asf.
Пікірлер: 11