Verygood! Thanks for posting. To study again in the very near future when I tackle this...opportunity to save money.
@aroundthehomesteadwithsuer3497
2 жыл бұрын
With the prices of everything going the way they are we all need to find any way we can to cut a few dollars on spending for sure. I have always enjoyed working on the vehicles. Sure it can have its moments that cause me to invent new words and chuck a tool across the garage but in general its rewarding to know I understand how it works
@LarryKapp1
3 жыл бұрын
ha ha - I just ordered a set of xzn sockets the other day because I got a 2005 VW Jetta recently and found out I needed those. I have a video of trying to figure out power drain issue on my car. Not sure if I figured out that issue since I had to jump it yesterday . It is a diesel. Today I took removed the glove compartment and trunk lights just in case those are staying on - hard to tell when you shut them if they are still on . here is my repair video kzitem.info/news/bejne/qH-ayIaspGSoqKw . When I do brakes now on older cars I just replace the calipers too - worth it in the long run. If the noise comes back rotate your tires and see if it moves with that. I have had bad tires make me think it was bad bearings a couple times in past - and it was just the tires after I replaced the bearings !
@CS-en5xz
2 жыл бұрын
So the hardest part of this job is taking off the rotor which you didnt show. This video is worthless
@aroundthehomesteadwithsuer3497
2 жыл бұрын
Um at 10:52 I take the screw out of the rotor and 11:13 I tap the rotor off, Sorry you must have missed that part?
Пікірлер: 6