Hello! This video is very informative. I will be performing the same work on my 2008 Accord coupe this weekend. How many NM of torque do the 10mm bolts get?
@kitlacaden
Жыл бұрын
11.NM and torque w/ sequence ;)
@alfredace
Жыл бұрын
@@kitlacaden Thank you sir!
@romanrebisz4205
7 ай бұрын
How do you take it out
@kitlacaden
7 ай бұрын
Just take it out.. little bit tricky need to puzzled..
@vendrabagus3074
2 ай бұрын
how to remove on rb1
@NJRt461
Жыл бұрын
👍👍👍. Good job. This could be my next project for the Acura MDX since I suspect the seal is leaking. I have seen minor (just a few drops) oil leaks from the bottom on front end of engine block near the exhaust manifold. The oil drips on the front engine mount and exhaust pipe so I smell oil burning. I have replaced valve cover and grommet gaskets, front camshaft cover seal and found no leak on any other common leaking areas of this J engine. Did I miss anything in your experience? Is it possible oil leaks from the manifold gaskets because I reuse the old one? Also I can hear engine hassle noise while acceleration.
@kitlacaden
Жыл бұрын
No problem with your exhaust manifold gasket, because no oil running in exhaust manifold... maybe you did not clean the old leaks thats why you smell burning oil when you use your car. ;)
@kitlacaden
Жыл бұрын
About the noise.. try to check your drive belt. Auto tensioner or idler pulley..
@NJRt461
Жыл бұрын
@@kitlacaden no noise when idle. Hear noise at over ~20 km per hour. I replace power steering o-ring but no helps.
@NJRt461
Жыл бұрын
Thank you so Much👍👍👍👍👍👍. I see this VVT solenoid gasket leak on Honda but my 2001 MDX is different. I may need to inject some dye to see where is leaking.kzitem.info/news/bejne/oqOBxXWarYimjXY
@kitlacaden
Жыл бұрын
In v6 engine.. replace vtec solenoid valve assembly if leaking..
Пікірлер: 13