In this video, I go over installing Pergo 4 in 1 transitions on concrete with no screws. When trying to install the metal U track they send with the transitions, its not always easy to lineup the whole perfect so that your transition is tight against the granite and tight against the other miters. Rather than fight it, I like to use a urethane glue, hot glue, and C A glue to get the job done. This will ensure that my transition will be tight at the miters and against the tile or hearth with maximum hold. Hope you enjoy the video!
Thank you to all the subscribers and supporters of this channel!
Tools You May Need: (affiliate links below)
Angle Finder
www.amazon.com/gp/product/B07...
CA Glue
www.amazon.com/gp/product/B01...
Laminate Cutter
www.amazon.com/gp/product/B07...
Speed Square
www.amazon.com/gp/product/B00...
Nail Puller (cats paw)
www.amazon.com/gp/product/B00...
Pry Bar
www.amazon.com/gp/product/B00...
Hammer
www.amazon.com/gp/product/B07...
Tape Measure
www.amazon.com/gp/product/B01...
Tin Snips
www.amazon.com/gp/product/B00...
White Putty
www.amazon.com/gp/product/B00...
Dark Walnut Putty
www.amazon.com/gp/product/B00...
DISCLAIMER: This video and description contains affiliate links, which means that if you click on one of the product links, I will receive a small commission (at no extra cost to you of course). This helps support the channel and allows me to continue to make videos like this. Thank you for your support!
Негізгі бет Installing Pergo 4 in 1 Transitions On Concrete With NO SCREWS!!
Пікірлер: 151