Thank you, Alex !! I hope that you had a nice Christmas !!
@bandsawlife2660
9 ай бұрын
Thank you.
@ryanevans8182
7 ай бұрын
Just installed mine…had been sitting in the package for about 3 months. All I can say is…not sure I’ll ever put the factory guide back in again aside from resawing. This thing is awesome!
@SteveBiologist
6 ай бұрын
Great instructions! I have this saw and the guide. One thing to add-- when done cutting, loosen the guide and then take tension off the blade, but leave a little tension so the blade stays where it was set. When ready to use again, just put full tension and then move the guide forward again. Otherwise, the blade will slide off the wheels.
@mikel4510
2 ай бұрын
Are we going to see you at the woodworking shows in the next couple years?
@bandsawlife2660
2 ай бұрын
@@mikel4510 sorry no, I’m afraid they’re dead.
@philipselman2564
9 ай бұрын
Mr. Snodgrass I've have a 14" Delta under the table one bearing is stuck will not roll by it's self- can I spray PB blaster to loosen it up --or take off the saw thanks
@bandsawlife2660
9 ай бұрын
kzitem.info/news/bejne/2neQsJawo6eTd4osi=xJx3gJZ1F6T-iy1V Try this, if it’s a metal cover any auto parts house will sell you a new one
@ryanevans8182
9 ай бұрын
This version is only available through Carter direct.
Пікірлер: 10